Leick Home 9240-WTGL User manual

Assembly Instructions, #9240-WTGL
Claudette Desk
---1/2---
Thank you for purchasing Leick Furniture products.
Contact customer service for comments or concerns.
800-558-8700 [email protected] todaysdesignhouse.com
Note:
A packet with complete set of hardware can be found by pulling the red ribbon that's
easily visible upon opening the box.
Top Assembly
Metal rails
A
B
C
D
E
F
1
1
1
2
Parts List
Allen Wrench
Flat Washers
Drawer Pulls
Short Bolts
Long Bolts
Machine Screws
4
6
10
1
2
2
G
H
I
J
Left Side Frame
Right Side Frame
2
KScrews

---2/2---
Step 3 Step 4
Step 1
Move up the desk top assembly at one top corner slightly to
insert the metal tube onto side frame's metal tube, also make
sure the side frame's metal tab goes underneath of the top
assembly's back panel. Insert 2 metal rails onto right side
frame, fasten top assembly and two metal rails with 3 short
bolts and 3 washers. Do not tighten.
1.1)
Fasten the tabs of metal frames to the back panel with
two screws.
3.1)
Adjust the levelers at the bottom of legs if needed.
4.2)
Step 2
2.1)
I
J
K
Pull out the drawer and fasten drawer pulls with
machine screws.
4.1)
HFG
G
E
GE
GF
H
C
B
A
D
D
D
Fasten the side panel of the top assembly onto the
right side frame with 2 long bolts and 2 washers.
Tighten.
1.2)
Do the same assembly steps on the left side as step 1.1
and step 1.2.
Push side frames onto metal rails leaving no gap
between the metal frames and drawer box, tighten all
bolts on step 1.1 and 2.1.
2.2)
Lift desk in direction of arrow below, two people
recommended for lift.
2.3)
Wire management hole on back of
desk: pull the disk out, run wires
,and snap disk back in place.