Leitner ACS User manual

Rev. A 1-2-2015 PAGE 1 OF 2
BEFORE INSTALLATION
1) READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
2) CLEAN INSTALATION AREA
3) MAKE SURE ALL TOOLS ARE AVAILABLE FOR INSTALL.
APPLICABLE MODELS:
ALL
Leitner Designs
25675 Taladro Circle Unit E
Mission Viejo, CA 92691
www.leitnerdesigns.com
TORQUE WRENCH
WITH 13MM DEEP
SOCKET
ACS Roof Top Tent Bracket instructions
1
PACKAGE CONTENTS
REMOVE CROSS BAR PAD AND ADJUSMENT KNOBS
1) REMOVE THE ENCAP AND RUBBER PAD FROM THE
CROSS BAR EXTRUSION. (FIG 1)
2) REMOVE THE FOUR ADJUSTMENT KNOBS AND
REPLACE WITH THE FOUR M8 LOCKNUTS SUPPLIED
IN KIT. MAKE SURE THE CROSS BEAMS ARE AS FAR
APPART AS POSSIBLE. TIGHTEN M8 LOCK NUTS TO
16 LB-FT (FIG 2)
M8 X 20 cap screw
(QTY.4)
M8 T-Bolt
(QTY.8)
M8 locknut
(QTY.16)
RTT Bracket
(QTY.4)
TOOLS REQUIRED
(fig 1)
(fig 2)

Rev. A 1-2-2015 PAGE 2 OF 2
1) ATTACHE TWO RTT BRACKETS TO THE INSIDE
FRONT AND INSIDE REAR CROSS BEAMS USING 8
T-BOLTS. LOSSLY TIGHTEN WITH M8 LOCKNUTS
SO THAT THE BRACKETS CAN STILL SLIDE. (FIG
3)
2) ADJUST THE BRACKEST AS SHOWN. THE
BRACKETS ARE STILL LOSE AND WILL BE
ADJUSTED IN A FUTURE STEP. (FIG 4)
3) YOUR ROOF TOP TENT SHOULD HAVE SHIPPED
WITH 4 SLIDE PLATES. INSTALL THE SUPPLIED M8
X 20 SCREWS INTO THE SLIDE PLATE AND
INSTALL TWO INTO EACH TENT MOUNTING RAIL.
(FIG 5)
4) USING A FORKLIFT (RECOMMENDED) OR 3 OF
YOUR STRONG FRIENDS LIFT THE ROOF TOP
TENT ONTO THE TOP OF THE RACK.
5) LIFT EACH CORNER OF THE TENT AND POSITION
THE M8 X 20 CAP SCREWS INTO THE HOLE ON
THE RTT MOUNTING BRACKET. LOOSLY TIGHTEN
THE M8 NUTS ONTO THE M8 X 20 CAP SCREWS.
(FIG 6)
6) CAREFULLY WALK AROUND THE VEHICLE AND
MAKE SURE THE TENT IS CENTERD ON THE RACK.
7) TIGHTEN ALL THE M8 LOCKNUTS TO 16IN-LB.
8) IS RECOMMENDED THAT YOU CHECK THE
TORQUE OF ALL THE BOLTS ON THE RACK AND
TENT FREQUENTLY TO INSURE EVERYTHING IS
TIGHT.
..
ATTACH RTT BRACKETS
1
(fig 4)
(fig 3)
M8 nut
T-bolt
RTT brackets
shown in
installed position
(fig 5)
M8 X 20
cap screw
Tent mounting
Rail
Slide plate
(fig 6)
M8
LOCKNUT