LENCO KCR-9 User manual

1
KC R-9
Instruction Manual

2
WARNINGS
BEFORE OPERATING YOUR APPLIANCE PLEASE READ ALL OPERATING INSTRUCTIONS, AND
SAFETY INSTRUCTIONS TO RECEIVE MAXIMUM ENJOYMENT. ALL INSTRUCTIONS SHOULD BE
PROPERLY FOLLOWED.
CAUTION: TO R EDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE
COVER (OR BACK) SINCE THERE ARE NO USER - SERVICABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED TECHNICIANS.
DANGEROUS VOLTAGE
This symbol indicates to the user that the voltage of the circuits is of sufficie nt magnitude to
constitute a risk of electric shock.
ATTENTION
This symbol indicates to the user that the instruction manual contains important operating and
maintenance instructions.
DRIPPING WARNING : The product shall not be exposed to dripping or sp lashing and that no objects filled with
liquids, such as vases, shall be placed on the product.
VENTILATION WARNING : The normal ventilation of the product shall not be impeded for intended use.
The Marking plate IS located on the bottom
MOUNTING
1. Choose a spot near an electrical outlet.
2. Rotate the 4 mounting adapter to choose apposite gap between the unit
and the spot.
3. Mark the mounting position.
4. Install the mounting adapter on the spot.
Note: Fixings used to mount this unit must be suitable for construction
material if in doubt consult builder.

3
LOCATION OF CONTROLS
1. Volume / AL 2. Display 3. Auto indicator
4. FM / MW Pointer 5. Alarm set / Off button 6 . Time set button
7 . Hour set button 8 . Minu te set button 9. De sktop s tandard
10 . C OUNT DOWN On / Off button 11 . Tuning control 12 . FM/AM switch
13 . On / Off / Auto switch 14. FM A ntenna 15. Battery compartment cover
16. AC Power Cord 17. Mounting adapter
POWER SUPPLY
Plug the radio power cord on the back of the radio into any regular AC outlet.
Never connect to a DC electrical outlet or to any other Voltage and cycles.
RADIO OPERATION
To turn the radio on manually:
Set the ON / OFF / AUTO switch on the ON position.
Adjust the volume control to the d esired volume level.
Turn the tuning knob until the dual pointer sets to the station of your choice.
ANTENNA
Unwind the throw - up antenna for FM reception and place it in the position which permits best reception.
CLOCK OPERATION
To set the correct time:
1. Press both the Time set button and the Hour set button together for hour adjustment of the time.
2. When you get close to the correct time, press Time set button and Minute set button for a slower and more
accurate time adjustment of minutes.
ALARM OPERATION
This clock radio gives you two choices of how to wake up. You may wake up to music of to a buzzer alarm.

4
TO SET WAKE UP TIME
Press Alarm button first and then press either Hour or Minute button until you reach the time you want to wake
up. When you relea se the alarm button the digital display will go back to the regular time.
WAKE UP TO MUSIC
To wake to music set the radio as follows:
1. Tune into your favo urite station and adjust the volume control so that the set plays loud enough to
wake up.
2. Adjust the a larm time to the time you want to wake up.
3. Slide the ON / OFF / AUTO switch to the auto position.
WAKE UP TO ALARM BUZ ZER
To wake up to alarm buzzer follow Wake to Music instruction and do the following:
Turn the volume control till a click is heard. In the morning the buzzer alarm will wake you up instead
of the music alarm.
To turn the buzzer off slide the ON / OFF / AUTO switch to the off position.
TO SET THE COUNT DOWN TIMER
You can set the count down timer for up to 1 hour and 59 minutes.
1. Set the ON / OFF / AUTO switch to either ON or OFF position.
2. Slide the COUNT DOWN On / Off button to ON position.
3. Adjust the desired time with hour and minute(s) you wish.
An alarm sounds at the timer start counting down towards zero.
POWER FAILURE
Y ou can insert a 9 volt battery in the clock radio. Should there be a power failure; the clock will continue to
function.
You will not see this, because the battery does not illuminate the clock display. As soon as the power is
switched on again, the displa y will indicate the correct time.
For clarity:
- Alarm, radio and display do not work on battery.
- Place the battery in the compartment on the underside of the clock radio.
- Replace the battery every 6 months (depends on life of the battery ).
INSTRUCTION MANU AL SHALL CONTAIN FOL LOWING TEXTS
a) The power switch in this unit is located on the secondary circuitry and does not disconnect the whole unit
from the mains in off position.
b) This unit must not be exposed to moisture of rain.

This document was created with Win2PDF available at http://www.daneprairie.com.
The unregistered version of Win2PDF is for evaluation or non-commercial use only.