Lenoxx YD1006 User manual

Installation instructions
Ride-on Children’s Excavator
Model: YD1006
Batch: PR4635
Please read and retain these instructions for future reference.
The illustrations used in this manual are to illustrate the operation method
and structure of the product. Where there is a small difference between the
physical item and the illustrations, please take the physical as the standard.
*Specifications Introduction:
Item Name
Specifications
Suitable Age:
3 years +
Load Capacity:
Under 25KG
Size of Car:
82 X 27 X 40CM
Battery for
Music:
3 x AA battery (not included)
Features:
squeaky horn on the steering wheel and operation levers to scoop and lift up
light items. Music

SAFETY INFO:
1. When unpacking the ride on, properly dispose of all plastic wrappings.
2. Adult supervision is required at all times.
3. Failure to follow the instructions may affect the safety of children.
4. This product is designed for use by children from 3 years to 6 years of age.
5. Protective equipment such as a helmet is recommended (protective equipment is not
included).
6. Assembly must be completed by an adult.
7. Before use, ensure that all removeable parts and fasteners are firmly in place.
8. Only one child can use this at a time.
9. Achild who is riding is not to be pushed.
10. Do not allow a child to stand on the ride-on.
11. Do not let children ride in the street, anywhere dangerous including stairs, doorsteps, steep
slopes, streets/roads, vehicle traffic, next to bodies of water and away from other obstacles. Use
during day light hours or in an illuminated area is advised to avoid accidents in the dark.
12. Do not drive on long or wet grass, mud, soft ground, gravel or sand.
13. It is not recommended for use on wooden floors. The wheels may damage some floors.
14. The maximum carrying capacity is 25kg.
Part list Part Diagram

1.
Body of excavator
2.
The back of seat
3.
The front wheel
4.
The front wheel cover
5.
Front axle and steering lever
6.
The steering wheel
7
The digging arm

Assembly
1. Pull the black plastic tube
out of the front, as shown in
Pictures 1.
2. Place the digger arm in
the middle of the front of
the car and insert the black
plastic tube into the hole, as
shown in Pictures 2 and 3.
3. Put the coil spring of the
digging arm into the hole of
the front of the car, as
shown in Pictures 1
4. Pull the coil spring out
from the bottom. The coil
spring covers the yellow
tubule. Place spacers and
screws to hold it in place, as
shown in Pictures 2 and 3.
5. Tighten the screws with
a screwdriver.
Complete the installation of
the digging arm, as shown
in Picture 4

6. Take the front axle,
the gasket, the steering
lever, and the yellow
plastic bushing,
as shown as Picture 1.
7. The front axle goes
first through the gasket,
then through the wheels
and yellow bushing, then
through the steering
lever, and in turn the front
wheels are installed,
as shown in Picture 2
and 3.
8. After the tire is all
installed, finally put the
gasket, insert the wire
into the hole of the front
axle, bend both sides of
the wire and fix it, as
shown in Picture 4, 5
and 6.
9.Finally, attach the two
tire covers to the
clamping slots.
The installation of the
front wheels is complete,
as shown in Pictures 7
and 8
10.Remove the screw
from the steering lever
and set aside.
Prepare to install the
steering lever and
steering wheel, as shown
in Picture 1 and 2.

11. Align the steering
lever with the hole and
insert it from the bottom
of the excavator, as
shown in Pictures 1 and 2
12. Install the steering
wheel in the steering
lever from top to bottom,
keeping in mind that the
steering wheel holes are
aligned with the steering
lever holes.
As shown in Picture 3
and 4.
13. Insert the screw into
the hole where the
steering wheel and
steering lever are
aligned, and then tighten
the screw. Complete
steering wheel
installation. As shown in
Pictures 5 and 6.
14. Insert the back of
seat into the slot.
Complete the installation,
as shown in Picture 7
and 8
15. Open the battery tank
at the bottom of the
excavator, put in 3 AA dry
batteries and then screw
the battery tank cover, as
shown in Pictures 9 and
10. Make sure to replace
the screws. Always keep
small parts and
batteries away from
Children to avoid
choking

Rules for Safe Riding:
• Keep Children within Safe Riding Areas: Never use in roadway, near motor vehicles, on lawn space, on
or near steep inclines or steps, swimming pools or other bodies of water;
• Use the toy only on flat surfaces. such as inside your house, garden or playground.
• Never use in the dark. A child could encounter unexpected obstacles and have an accident. Operate
the vehicle only in the daytime or a well-lit area.
• It is not recommended to drive the vehicle on wet surfaces or on lopes of greater than 15 degrees.
• Do not use this vehicle outdoors when it is raining or snowing.
• Please follow the correct weight and age limits allowed to drive this vehicle.
• In order to avoid accidents, please ensure the vehicle is safe before riding.
LENOXX ELECTRONICS AUST PTY LTD
www.lenoxx.com.au
Tel: [phone]
LenoxxElectronics @ LenoxxAustralia Lenoxxelectronics