Ⅱ.Safety instructions
1. Before mounting and maintenance please make sure that the electrical supply has been switched off to avoid
electric shock.
2. The lamp must be earthed.
3. The power cord must be VDE-certified H07RN-F 3x1.0mm2waterproof cable.
4. Replace any cracked protective shield
5.If the external wire or power cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person to avoid the hazard.
6. Please pay attention to that do not touch the back of lampbody while working.
7. Tripod legs must be fully extended in normal use for maximum stability.
8. The whole lamp is very convenient to use, it applicable to any place to use portable lamps and lanterns,
triangle stents lamp when using aircraft and ground of not more than 15 ° angle .
Ⅲ. Assembly steps
1. Loosen screw, fully open the legs,then re-tighten the screw.
2. Adjust the tripod’s height(higher or lower) by Knob.
3. Fix the lamp on the tripod by Screw and it can adjust the lamp to the right or the left.
4. Check if the tripod is stable and it has a firm footing. Ensure cable is not touching any sharp objects and
the mains plug connector is adequately protected against rain or moisture. Now your lamp is ready for
use.
Ⅳ Maintenance
CAUTION: The light source of this luminaire is not replaceable, when the light source reaches its end of life
the whole luminaire shall be replaced.
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
Cixi Zhongfa Lamps Co.,Ltd.
No, 188, 2nd Xingci Road,Economic Development Zone,Cixi City,Ningbo 315336 P. R. China