LX-R3 BLUETOOTH INTERPHONE
5.2.4. To terminate the phone call, short press the Phone/Play Button.
Note: In some case (e.g. high power RF radio influence or metal block), the headset
will be disconnected from the cell phone, please short press the Phone/Play Button to
reconnect them.
5.3 Intercom Conversation
5.3.1. You can start an intercom conversation with the other Intercom Riders by
pressing the Power/Interphone Button.
5.3.2. To terminate an intercom conversation, short press again the Power/Interphone
Button.
5.3.3. When in 3 rider small group conversation, to start an intercom conversation,
short press the Power/Interphone Button on Headset Ato talk with Headset B. While
if the Headset A want to talk with Headset C, press & hold the Power/Interphone
Button until you hear a beep ”du-du”, promptly release your hand, then it will connect
with the Headset C.
Note: For these 3 paired headsets, only two headsets could be set as master units, and
the third one is slave unit and cannot start an intercom conversation, when one of the
master unit switch to talk with the third(slave) unit, the third(slave) unit will become
master unit.
5.3.4. When you try to start an intercom conversation with an Intercom rider who is
already having an intercom conversation or a mobile phone call with another person,
you can’t make it and will hear low tone double beep as a busy signal. In this case,
you have to try again later.
5.3.5. If your Intercom rider goes out of range while having an intercom conversation,
you may hear static noise and eventually the intercom will be disconnected. In this
case, the LX-R3 automatically tries to reconnect the intercom every 8 seconds and
you will hear high tone double beeps until the intercom is reestablished. If you don’t
want to make a reconnection, short press the Power/Interphone Button to stop the
attempt.
5.4 Stereo Music
You can listen to stereo music in either way: by Bluetooth wireless stereo or with the
enclosed stereo audio cable.
• By Bluetooth Wireless Stereo
The Bluetooth audio device must be paired with the LX-R3 by following the
Bluetooth Audio Device Pairing instructions described in the previous chapter. The
LX-R3 supports the AdvancedAudio Distribution Profile (A2DP), so if your
Bluetooth audio device also supports the A2DP, you can use the LX-R3 to remotely
control music playback. You may not only adjust the volume but also use the
functions such as play & pause.
- Press Volume + or Volume –Button to adjust the volume
- Press Phone/Play Button to play/pause the music
