Lexmark C925 User manual

Print defects guide
Repeating defects measurements
Match a set of repeating defects ona print job to the marks on one of the vertical lines. The line that best matches the defects
on the print job indicates which particular part is causing the defect.
Note: Make sure the current selection in the printer for Scale to Fit in the PDF menu is set to No for the rulers to be printed at
the correct size.
Change the imaging unit if the repeating defects appear in these
instances:
•every 41 mm (1.61 inches) of the page
•every 75 mm (2.95 inches) of the page
Note: The printer has four imaging units. Replace the imaging
unit that has the same color as the repeating print defect.
Change the fuser if repeating
defects appears on every
141 mm (5.55 inches) of the
printed page.
Change the transfer module if
repeating defects appears on
every 38 mm (1.5 inches) of the
printed page.
Print defects guide
Page 1 of 1