Lexmark Pro800 User manual

1Unpack printer
Notes:
•Place the printer near the computer
during setup. If you're setting up on
a wireless network, then you may
move the printer after setup is
complete.
•Do not attach the USB cable until
prompted to do so.
•The packaged printhead is shipped
inside the printer.
•Contents may vary by model and
region.
2Remove tape and packing material from all areas of the
printer
Lexmark Pro800 Series Installation

3Open printer and remove packaged printhead
4Close printer
5Pull paper tray completely out of printer
Lexmark Pro800 Series Installation

6Move paper guides to the sides
7For A4 or Legal, extend paper tray
8Load paper and adjust paper guides
Note: Do not load paper past the
maximum height indicator line as shown
in step 2.
Lexmark Pro800 Series Installation

9Insert paper tray
10 Connect power cord only
Note: DO NOT attach the USB cable yet.
CAUTION—POTENTIALINJURY: Read the safety information included with this product before connecting
power or making any cabling connections.
11 Make sure printer is on
Lexmark Pro800 Series Installation

12 Follow prompts on the printer control panel
1Follow the prompts on the printer
control panel.
2After following the prompts, click
Continue below.
13 Install printhead and ink cartridges
If you need to install the printhead and
cartridges, click Continue.
If not, you can close this window.
14 Open printer and remove any tape from latch
Note: The carriage moves to the
printhead installation position as shown.
Lexmark Pro800 Series Installation

15 Squeeze and lift latch
16 Remove printhead from disposable container
17 Insert printhead and close latch until it clicks
Lexmark Pro800 Series Installation

18 Close printer
19 Open printer
Note: The printhead moves to the
cartridge installation position as shown.
20 First, insert each color ink cartridge. Then, use two hands
to install black cartridge.
Lexmark Pro800 Series Installation

21 Close printer
22 Flip and extend exit tray paper stop
Notes:
•Extend the paper exit tray for
A4/Legal.
•The paper stop holds paper as it exits
the printer.
23 Touch OK to print alignment page
Notes:
•Do not remove the page until
printing stops. The alignment page
may take a while to print and will
move in and out during the process.
•Streaks on the alignment page are
normal and not an indication of a
problem.
•The alignment page that prints may
differ from the one shown.
•Recycle the alignment page.
Lexmark Pro800 Series Installation