Lexmark S300 User manual

1Unpack printer
Notes:
•Place the printer near the computer
during setup. If you're setting up on
a wireless network, then you may
move the printer after setup is
complete.
•Do not attach the USB cable until
prompted to do so.
•The packaged printhead is shipped
inside the printer.
•Contents may vary by model and
region.
2Remove tape and packing material from all areas of the
printer
Lexmark S300 Series Installation

3Raise paper support
4Raise printer control panel
Lexmark S300 Series Installation

5Open printer and remove packaged printhead from
printer
6If necessary, insert correct (1) language overlay and install
(2) protective cover
Lexmark S300 Series Installation

7Lock the protective cover in place
8Close printer
Lexmark S300 Series Installation

9Use lever to extend paper guides
10 Load paper
Note: Use the lever to adjust the paper
guides.
Lexmark S300 Series Installation

11 Extend paper exit tray
12 Connect power cord only
Note: DO NOT attach the USB cable yet.
CAUTION—POTENTIALINJURY: Read the safety information included with this product before connecting
power or making any cabling connections.
13 Make sure printer is on
Lexmark S300 Series Installation

14 Set language
1Using the printer control panel, press
or until the language you want
appears on the display.
2Press OK to save.
15 Set country/region
1Using the printer control panel, press
or until the country or region
you want appears on the display.
2Press OK to save.
16 Open printer and remove any tape from latch
Note: The carriage moves to the
printhead installation position as shown.
Lexmark S300 Series Installation

17 Squeeze and lift latch
18 Remove printhead from disposable container
19 Insert printhead and close latch until it clicks
Lexmark S300 Series Installation

20 Close printer
21 Open printer
Note: The printhead moves to the
cartridge installation position as shown.
Lexmark S300 Series Installation

22 First, insert each color ink cartridge. Then, use two hands
to install black cartridge.
23 Close printer
24 Press OK to print alignment page
Notes:
•Do not remove the page until
printing stops. The alignment page
may take a while to print and will
move in and out during the process.
•Streaks on the alignment page are
normal and not an indication of a
problem.
•The alignment page that prints may
differ from the one shown.
•Recycle the alignment page.
Lexmark S300 Series Installation