LG PD269SF User manual

Owner’s manual
Please read this manual carefully before operating
your device.
MODEL : PD269W / PD269P / PD269B / PD269SF
ENGLISH
The actual device may differ from the image.
Bluetooth®

2
Safety information
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK) NO USER-
SERVICEABLE PARTS INSIDE REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
This lightning ash with arrowhead symbol
within an equilateral triangle is intended
to alert the user to the presence of
uninsulated dangerous voltage within the
product’s enclosure that may be of sufcient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence
of important operating and maintenance
(servicing) instructions in the literature
accompanying the product.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN
OR MOISTURE.
WARNING: Do not install this equipment in a conned
space such as a book case or similar unit.
CAUTION: Do not use high voltage products around
this product (ex. Electrical swatter). This product may
malfunction due to electrical shock.
CAUTION: Do not block any ventilation openings. Install
in accordance with the manufacturer’s instructions.
Slots and openings in the cabinet are provided for
ventilation and to ensure reliable operation of the
product and to protect it from over heating. The
openings shall never be blocked by placing the product
on a bed, sofa, rug or other similar surface. This product
shall not be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is provided
or the manufacturer’s instruction has been adhered to.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN

3
CAUTION concerning the Power Cord
Most appliances recommend they be placed upon a
dedicated circuit;
That is, a single outlet circuit which powers only that
appliance and has no additional outlets or branch
circuits. Check the specication page of this owner’s
manual to be certain. Do not overload wall outlets.
Overloaded wall outlets, loose or damaged wall outlets,
extension cords, frayed power cords, or damaged
or cracked wire insulation are dangerous. Any of
these conditions could result in electric shock or re.
Periodically examinutese the cord of your appliance,
and if its appearance indicates damage or deterioration,
unplug it, discontinue use of the appliance, and have
the cord replaced with an exact replacement part by an
authorized service center. Protect the power cord from
physical or mechanical abuse, such as being twisted,
kinked, pinched, closed in a door, or walked upon. Pay
particular attention to plugs, wall outlets, and the point
where the cord exits the appliance.
The Power Plug is the disconnecting device. In case
of an emergency, the Power Plug must remain readily
accessible.
This device is equipped with a portable battery or
accumulator.
Safety way to remove the battery or the battery
from the equipment: Remove the old battery or
battery pack, follow the steps in reverse order than
the assembly. To prevent contaminutesation of the
environment and bring on possible threat to human
and animal health, the old battery or the battery put it
in the appropriate container at designated collection
points. Do not dispose of batteries or battery together
with other waste. It is recommended that you use
local, free reimbursement systems for batteries and
accumulators. The battery shall not be exposed to
excessive heat such as sunshine, re or the like.
NOTICE: For safety marking information including
product identication and supply ratings, please refer to
the main label inside the apparatus.

4
CAUTION:
yThe apparatus should not be exposed to water
(dripping or splashing) and objects lled with liquids,
such as vases, shouldn’t be placed on the apparatus.
yMinimum distance around the apparatus for
sufcient ventilation, no less than 5 cm.
yThe ventilation should not be impeded by covering
the ventilation openings with items, such as
newspapers, table-cloth, curtains etc.
yNo naked ame sources, such as lighted candles,
should be placed on the apparatus.
yThe unit’s internal lithium battery should only be
serviced by an authorised service centre.
Device operating temperature
When operating in cold weather, the device shall
not print. Bring it inside from the cold and give
about 10 minutes to adjust to the specied
operating temperature (5 °C - 40 °C). Then
try printing again. (For the appropriate use, it
is recommended not to operate it outdoors in
winter.)
, Note
CAUTION when using this product in
environments of low humidity
yIt may cause static electricity in environments
of low humidity.
yIt is recommended to use this product after
touching any metal object which conducts
electricity.
> Caution

5
Contents
Safety information ......................2
STEP 1 Getting Started ..................6
Supplied items ............................. 6
Product Overview . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Open / Close the door ...................... 7
Power On / Off............................. 8
STEP 2 Charging Battery.................9
STEP 3 Inserting Photo Paper ...........11
Cleaning printer head using Smart Sheet ..12
About photo paper........................13
Paper Jam Solution ........................14
STEP 4 Installing App ...................15
Installing App for Android phone ..........15
App Setting ..............................15
Installing App for iPhone ..................16
Setting Bluetooth of iPhone ..............16
STEP 5 Printing Photo ..................18
Printing using Android phone .............18
Printing using iPhone .....................21
Using the edit mode.......................23
Notes on the printing .....................23
Checking where to buy paper .............24
Updating the device .......................25
Checking Label .........................26
About LED Indicator ....................27
Specifications ..........................29
Troubleshooting ........................30

6
STEP 1 Getting Started
Supplied items
USB cable
yDepending on the model or region, supplied
items may differ. (ex. USB cable, photo paper
etc.)
LG Pocket Photo Printer Simple manual
Product Overview
Paper exit slot
Power button
LED Indicator
Paper tray
Micro USB port
(for recharging)
Reset hole
Photo paper

7
Open and close the door
Open
1. Slide the door to release it.
2. Open the door.
(Be sure to slide the door completely.)
Close
1. Match the loactions of latches and close the door.
2. Slide the door to x it.

8
Power On / Off
Press power button for 2 seconds to turn on or off.
yWhen turning the device on, LED indicator
ashes for 3 seconds, then printing is
available.
yFor more information, see “About LED
indicator”.
, Note

9
STEP 2 Charging Battery
This device uses a built-in battery. Before using it, fully
charge the battery using a smart phone USB data cable
(Micro 5 pin) or adapter. (Refer to below)
Battery charging time : 1.5 hours
Checking the charging status with LED indicators
y: Power-off : Charging : Full charge
y0 % : ashes for about 30 seconds. and turns off.
yLG Pocket Photo is always charged when connected
to the power supply except for being printed.
yTo charge this product, you must always use a DC
5 V, 1A or more. Certied/Listed Adapter which
complies with LPS.

10
yHandle with care during charging to prevent
electric shock.
yDo not place near heating appliance.
yDo not disassemble or deform.
yDo not give shock on.
yAvoid too high or low temperature or humidity.
> Caution
yYou can connect the device to PC using a
Smart phone USB data cable, but charging
time can be longer.
yThe operating time on battery may vary
depending on the battery status, operational
status and environment conditions.
yWhen the battery is discharged, printing is
available after charging it for more than 10
minutes. (Charge in full to print in a row.)
, Note

11
STEP 3 Inserting Photo
Paper
1. Open the door
2. Unpack the photo paper pouch you bought.
3. Slide smart sheet (blue) and photo papers together
into the paper slot, then close the door. Smart Sheet
will be ejected automatically before rst printing.
yDo not insert more than 10 Photo papers and
1 Smart Sheet. Otherwise 2 papers may be ejected
at once or paper jam may occur.
yOnce the pack is unwrap, keep the remaining papers
after using in an airtight plastic bag.
Arrange all papers and smart sheet to end of
rear.
Smart sheet
with barcode
side down
Photo paper
with white
side up

12
Cleaning printer head using Smart
Sheet
Smart sheet (Cleaner)
When you insert new smart sheet and photo papers,
this device scans the barcode of smart sheet to
maintain optimized photo paper. (It will be ejected
before the rst printing.)
To maintain the best quality, remove foreign material of
the head using cleaning feature.
When using Smart Sheet, it should be used with
photo papers in the same pouch.
yUsing smart sheet from other pouch may
result in low quality.
yIf print quality is abnormal or low, print out
the smart sheet 3-5 times repeatedly.
yReuse the smart sheet until use up the
photo papers from same pouch.
Note on Smart sheet

13
About photo paper
Photo paper pouch
Use exclusive photo paper for LG Pocket Photo.
Otherwise, the print quality cannot be guaranteed,
and it may cause damage of Pocket Photo.
yDo not damage or bend the papers.
yUsing soiled paper may result in malfunction.
yEnsure to use the papers within its valid date.
Note on Photo paper

14
yHandle with care not to get dirt on, when you
touch the paper.
yOnce unpacked, the papers may begin to
curl up or discolor after a period of time. It is
recommended to use them as soon as possible.
yUsing photo papers from other company may
result in malfunction, paper jam or low quality.
yDo not place inside a car or, expose to direct
sunlight or moisture.
yDo not leave in a place where the temperature
or humidity is too high or low. It may reduce
the quality of the printed photo.
Note on Photo paper Paper Jam Solution
Do not pull the paper out. Turn the device off and on
again, the paper will be ejected automatically.
yIf there are foreign material or dust on the roller, it
may not be ejected properly.
In that case, remove the foreign material of the head
with scotch tape rst. And then, clean using smart
sheet and try again.
yIf the photo paper has bent, paper jam may occur.
yIf this problem is not solved, please refer to
“Troubleshooting”.

15
STEP 4 Installing App
Installing App for Android phone
Bluetooth®
From Play Store (Android market)
Search for “LG Pocket Photo”.
Using QR code
Scan the QR code on the product box.
App Setting
Bluetooth®
Set the options in [Setting].
yBluetooth : Prints using Bluetooth
yTo optimize printing photo, activate all modes and
use pocket photo App.

16
See “Help” for details
For more information about the App, touch [Help]. Installing App for iPhone
From App Store
Search for “LG Pocket Photo”.
Using QR code
Scan the QR code on the product box.
Setting Bluetooth of iPhone
1. On your iPhone’s home screen, touch [Settings].
2. Touch “Bluetooth” and touch the slider to turn
Bluetooth [On].

17
3. To connect your Pocket Photo device to the iPhone,
turn on your device and make sure it is discoverable
mode.
4. When you nd the device, touch the model name of
Pocket Photo on the screen.
See “Help” for details
For more information about the App, touch [Help].

18
STEP 5 Printing Photo
Printing using Android phone
Bluetooth®
Printing using Bluetooth (
Bluetooth®
)
Preparation : Turn the device on, and start printing with
the LED indicator turning on.
1. Run LG Pocket Photo App on Android phone.
2. Select a photo to print, and touch [ ].
3. Touch [OK], then it will start searching for Bluetooth
devices.
yTo print, set print mode or the number of photo
on the preview screen.
4. When LG Pocket Photo is paired for the rst time,
[Bluetooth pairing request] appears. To start printing,
touch [Pairing] or input the PIN code ‘0000’.
yIf Smart Sheet is in the device, it will be ejected
before the printing starts.

19
,You can print photos directly from Android phones
or PC via Bluetooth without the App. Choose a
photo and select [Bluetooth] in [Share] or [Menu].
yCheck the power of the Pocket Photo, when
your device can not search for Bluetooth device.
yThe photo le less than 10 MB can be printed.
ySetting screen may differ depending on the
phone manufacturer.
yWhen connecting to the other company’s
smartphone, some functions may be limited
depending on conditions.
> Caution

20
Setting Pocket Photo App of Android phone
You can check device/battery status, the number of
photos printed, MAC address and device version. And
you can change setting of print mode and Auto power
off.
1. Run LG Pocket Photo App on Android phone.
(To check [Device information], set to [On] the
Bluetooth of smartphone.)
2. Go to Setting.
3. Touch [Device Information].
4. [Print setting]
Paper Full Prints without white space. (The
edge of the image can be cut off.)
Image Full Prints an image as a whole.
(White space can occur at the
edge of the paper.)
Automatic Device
Power Off
Set a time so that the device
turns itself off.
(Default is [5 minutes].)
yThe longer time you set [Automatic Device
Power Off] to, the more the battery
consumption is. The number of maximum
prints may differ.
yIt is recommended to keep default setting of
the device.
, Note