Product introduction .
How does the LIBAIRATOR
®
operate? How does the salt-rich air created by LIBAIRATOR
®
work?
The device produces superfine dry salt particles and releases them into the air by means of a patented process. The intensity of
the produced salt-rich airflow varies according to the distance from the device and head-level. The salt particles partly adhere
to the upper respiratory tract and partly reach the lungs. The salt-rich air
● in smaller concentration acts calmingly, diminishes swelling of the mucous membrane, and helps dissolve and detach
mucus
● in higher concentration helps dissolve and detach mucus in a more pronounced manner and encourages mucus
clearance.
Due to its working principle, the device’s fan spins up in periodic intervals. The salt particles gradually fill a closed air space.
First-time operation .
Where and how should the LIBAIRATOR
®
be placed? How should it be installed?
Place the device to face you, in a (close to) horizontal position, so that the side with the Libairator
®logo is on top. To keep the
Libairator
®in place, use the supplied sticky pad (Figure A&B).Night use is especially recommended. Optimal results can be
achieved if placed at the appropriate distance (see Chapter Use of the device ), therefore, at night, place it on the bedside in
the bedroom and the children’s bedroom, during the day in the living room, on the desk, or the dashboard of your car.
Take the device out of its resealable moisture protection bag. Leave the desiccant sachet in the bag. Reseal the bag and keep
it for future use. Take the sticky pad out of its packaging and remove the protective film from both sides. To keep the
Libairator
®in place, always use this sticky pad, that also serves as a resonance damper (Figure A). Take the power adapter
and the USB cable out of their packaging. Connect the USB cable to both the device and the adapter. Then, plug the adapter
to the mains or the cable to another standard-compliant USB power source. Make sure that the back of the device and the
power adapter are easily accessible for putting out of service, which takes place by disconnecting from the power source. The
rumbling noise that may be heard if placed on thin furniture can be eliminated by folding up the first 3 centimetres of the sticky
pad and attaching it to the bottom of the front part of the device (Figure B). In case this does not help, place the device on a
more massive surface, or, for example, put a thick towel or pillow under the sticky pad.
User manual web EN ● Version: V03 ● 26/02/2018 ● Libairator LIB-111-W/B ● Page 10/16
