Lifestyle Array K1 User manual

Array K1/K2
Wheelchair
Limited Lifetime warranty against manufacturing defects.
This warranty does not cover product failure due to misuse,
negligence, improper storage or handling, improper operation
or unauthorized modifications.
Normal wear and tear on non-durable components, such as
rubber accessories and casters are not covered under this
warranty. These items are subject to normal wear and need
periodic replacement.
For Warranty Service, it is recommended but not required that
the product be returned to the Lifestyle Mobility Aids dealer
through whom it was originally purchased. However, all
Lifestyle Mobility Aids Dealers are qualified to assist you in
obtaining warranty service. If the product is to be returned to
Lifestyle Mobility Aids, prior authorization will be required.
In the event of a defect covered by this warranty, Lifestyle
Mobility Aids will determine if the product will be repaired or
replaced.
Do not attempt to adjust or operate wheelchair without
reading carefully all instructions in this manual.
Do not use as an occupant restraint in a motor vehicle. User
must always transfer to the vehicle seat.
Do not operate on streets, roadways, grass, slippery surfaces,
stairs or escalators.
Wheel locks are not brakes and are not to be used when
wheelchair is moving. Wheel locks are only intended to keep
the wheelchair in place when it is at a complete stop.
Always engage wheel locks before transferring and when
using a wheelchair lift or elevator.
Do not attempt inclines or declines greater than a 10% grade.
Do not stand or step on the footplates while transferring to or
from your wheelchair. This could cause the wheelchair to tip
or may cause personal injury or damage to your wheelchair.
To reduce the risk of tipping: Before leaning or reaching
forward, sit back in the seat and make sure casters are
rotated fully toward front of wheelchair. Do not lean over the
top of the wheelchair back. Do not tie down or attach
anything to the wheels. Do not stand on Footplates.
Unauthorized modification or the use of unauthorized
replacement parts could change the structure of the
wheelchair, void the warranty, and create a hazardous
condition resulting in serious personal injury.
300 LBS
WEIGHT CAPACITY

TO SET UP WHEELCHAIR
Open wheelchair by tilting to one side and pushing
down on seat rail until opened.
Attach Footrests by aligning holes on tabs at top of
Footrests with hinge pins on outside of front frame,
then swing Footrests to front until Footrest Release
Levers lock into place.
Adjust Footrest length (while user is seated) by
loosening the cam lever just above the Footplate,
pushing in the adjustment button and sliding the
inner tubing up or down to desired setting until the
adjustment button protrudes fully from the
adjustment hole. Then snap cam lever back into
place.
Make sure the Footplate is at least 2.5” from the floor
for proper clearance.
TO FOLD WHEELCHAIR FOR STORAGE
Make sure the Footrests are in the forward locked position
with the Footplates in the vertical position or REMOVE the
Footrests by pulling the Release Levers, swinging the
Footrests outward and lifting them from the hinge pins.
Standing behind the chair, grab the center of the seat and
pull up until closed.
Clean frame with a damp cloth and dust weekly.
Clean upholstery and armrests with mild soap and
water.
Never use abrasive cleansers or scouring pads.
If exposed to liquid, dry the wheelchair thoroughly as
soon as possible.
If any component appears worn or is not working
properly, contact an authorized dealer for repair
and/or appropriate replacement parts.
Solid rubber tires need minimal maintenance, but
should be cleaned occasionally with a damp cloth.
If tires become severely worn or cracking appears,
contact an authorized dealer.
Wheels and Casters should be checked periodically
and adjusted and lubricated as needed by an autho-
rized dealer.
LIFESTYLE MOBILITY AIDS
3200 Tyrone Blvd N
St. Petersburg, FL 33710
Email: [e-mail]
Website: www.lifestylemobilityaids.com
V3: 3/26/21