Lighthouse Elite L/HEBIKEFRR User manual

Specifications
Product code: L/H EBIKEFRR
This bike light set utilises the latest technology
in portable lighting, allowing extremely bright
LED lights to be encased in lightweight and
compact units.
The powerful 150 lumen front light features
three light settings:
• High 100% , • Low 50%, • Strobe.
The rear light has six settings:
• Solid High, • Solid Medium, • Solid Low,
• Flashing High, • Flashing Low, • Strobe
Battery Recharging
The light must be fully charged for a
minimum of 5 hours before being used for
the first time, this will ensure that the battery
gives its best performance now and on future
re-charging cycles.
The charging cable is for recharging the
battery only. It cannot be used to directly
power the light.
Failure to recharge the light every 3 months
may permanently damage or reduce the
performance of the light. The battery charge
does not have to be fully depleted before
recharging.
Using the Charging Lead
Plug the USB charger lead into the micro
USB charging socket on the back of the light.
Plug the other end of the lead into any USB
charging outlet.
While on charge the charging indicator lamp
will glow red. It will turn green when the
battery is fully charged (approximately
5 hours).
Please note the following
1) For best performance Li-polymer batteries
should not be stored for prolonged periods
without being charged at regular intervals.
2) It is recommended to keep the battery in a
state-of-charge of 40-50 percent when
placing in storage. If in doubt, keep the
light in a higher charged state in a cool
place.
3) Self-discharge rate is approximately
10% per month.
148 x 210mm
2.5 / 4.5 hours
150 Lumens
XPG 3W LED
IP54
Water resistant
1M
Impact resistant
Battery
3.7V 800mAh
Li-Polymer
3.7V 330mAh
Li-Polymer
Charge time
approx 5 hours
Brightness
Light source
Run time
52g
Weight
62 x 30 x 30
Dimensions
(mm)
Rubber attachment straps
USB charging cable
10 hours
100 Lumens
COB LED
IP54
1M
approx 5 hours
High / Low /
Strobe
Modes
Solid / Flash /
Strobe
37g
41 x 41 x 38
Supplied with
Front Rear

Cleaning
Clean the lights using a soft cloth
dampened with a soap and water solution.
Do not immerse or submerge the light in
water or any other fluid.
Maintenance
There are no serviceable parts inside this
light. Opening or visible attempts to repair
the light will void any guarantee.
LED bulbs should not wear out under
normal conditions and do not need to
be replaced.
Never attempt to open a battery,
as liquid may be ejected, if
accidental contact occurs flush
the affected area with water. If the
liquid comes into contact with the
eyes flush with water and seek
medical help. Liquid ejected from
batteries may
cause irritation or burns.
Li-polymer batteries are formulated
from environmentally sensitive
materials and must be disposed
of properly.
Please return these batteries to your
local recycling centre where they will
be recycled or disposed of properly.
Never attempt to incinerate batteries
as they may leak or explode.
One-Year Home Use Limited Guarantee
Lighthouse guarantees this product to the
original purchaser for a period of ONE
YEAR against any defects in material or
workmanship but shall not cover damage
caused by misuse, abuse, alteration, or
accident. This product is intended for home
use only and the guarantee will not cover
products used for commercial purposes.
Operating Instructions
Fitting
Attach the white front light to your bikes
handlebars by hooking the rubber strap
over the light brackets hooks.
Attach the red rear light to the seatpost by
hooking the rubber strap over the light
brackets hooks. The rear bracket has a
ratcheting angle adjustment.
The bike light output functions are
controlled by a sequential switch:
Front Light
• Press and release the button to turn on
high brightness mode.
• Press and release button again to turn on
low brightness mode.
• Press and release button again to change
to strobe mode.
• Hold the button down for 3 seconds to turn
the light off.
Rear Light
• Press and release centre button to turn on.
• Press button again to cycle through the
solid modes - low, mid, high.
• Double click the button to toggle mode
between solid and flashing.
• Press button to cycle through flashing
modes - low flashing, high flashing, strobe.
• Hold button down for 3 seconds to turn off.
• The light will remember the last setting
used when turned on again.
Running times
Under optimum conditions, with a full charge,
the front light can normally be used for 2.5
hours in high or 4.5 hours in low or strobe
mode. The rear lights charge will last for up
to 10 hours.
The operating button will glow green when
sufficient battery charge is left.
The button will turn red to indicate charge is
low. Recharge the light as soon as possible. www.lighthouse-torches.com
Lighthouse Torches, Phoenix House,
3 White Lodge Business Estate,
Hall Road, Norwich, Norfolk, NR4 6DG
148 x 210mm