Lightolier LYEDROP FIXTURE Guide

!NSTRUCTIONSFOR INSTALLATIONOF
L~EDROP FIXTURE
INSTRUCTION SHEET NO.
IS:8626
FOR USE WITH 8600 SERIES POWER JACKS ONLY 1189
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these Instructions for maintenance reference.
MOUNTING
1. If used with POINT POWER JACK #8605, use the cap marked “35W MAX’ If used with other POWER
JACKS, make certain that the STEM BUSHING is removed from the POWER JACK ENTRY (Fig. 2).
2. Screw the JACK ASSEMBLY fully into the POWER JACK (Fig. 2).
INSTRUCTIONSFOR LAMPING
CAUTION: MAKECERTAINTHATTHELYTEDROP FIXTURE IS COOL BEFORE HANDLING. SINCE THE IAMP
HENS QUICKLY, MAKE SURE THAT THE POWER IS DISCONNECTED BEFORE INSERTING LAMP
INTO THE LAMP SOCK=.
1,
2,
3.
SEPARATE
Lift the GLOBE ASSEMBLY (with STYLE JACK SHADE) while rotating to the LE~ until it is released from
the LAMP SOCKET ASSEMBLY (Fig. 1).
lN~ALL LAMP
CAUTION: DO NOT TOUCH THE IAMP WITH BARE HANDS.
Oils from the hands could reduce L4MP life. Use tissue paper or asoft cloth. Insert the LAMP into the
SOCKET holes as far as it will go. Pins will be exposed approximately h“ outside of the SOCKET when
fully enaaaed. No ~olarity of Dins is required.
.- .
REASSEMBLE (Fig. 2).
FIG. 1
I
NOTE: Lamp replacement:
Tungsten-Halogen, T-4
Bi-Pin 6.35 base 35W mex
POWER JACK ENTRY ~35wMAx.cAp
-/IIoOR
69
STEM BUSHING
REMOVED
JACK ASSEMBLY
LAMP SOCKET
/‘SSEMBLY
ILAMP (SEE NOTE)
/
GLOBE ASSEMBLY
STEM 1[
\‘--------
NOTE: THE STEM
TO SEPARATE CONCEALED FLEX
FIG.
HAS A
TO TO REPLACE
ABSORB IMPACT.