Lightolier BOWSHIELD “ADA” WALL BRACKET SERIES Guide

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
INSTRUCTION SHEET NO.
IS:40825
0998 Page 1 of 1
INSTRUCTION SHEET FOR INSTALLATION OF BOWSHIELD™“ADA” WALL BRACKET SERIES
NOTE: This instruction sheet covers several fixture
styles. Backplate, lamp type and diffuser assembly
may vary slightly from that shown, although installa-
tion is the same.
BACKPLATE INSTALLATION:
1. Thread CROSSBAR MOUNTING SCREWS into CROSSBAR as
shown (Fig. 1).
2. Using appropriate slots in CROSSBAR, secure CROSSBAR to
OUTLET BOX using OUTLET BOX SCREWS (provided with
OUTLET BOX.)
3. While supporting BACKPLATE ASSEMBLY make connections:
black fixture lead or fixture lead without tracer marks to hot
(black) supply lead; white fixture lead or fixture lead with trac-
er marks to neutral (white) supply lead. Uninsulated fixture
wire is a ground wire and must be connected to grounding ter-
minal or ground lead inside OUTLET BOX. Use WIRE NUTS
(local hardware item). Push supply wires and connections back
into OUTLET BOX.
4. Position BACKPLATE over CROSSBAR
allowing CROSSBAR MOUNTING SCREWS
to come through holes in BACKPLATE ASSEMBLY.
5. Secure BACKPLATE ASSEMBLY in position by installing two
BATTERY NUTS over CROSSBAR MOUNTING SCREWS and
tighten.
6. Install recommended lamp(s).
DIFFUSER INSTALLATION:
1. Slide DIFFUSER down into NOTCHES in BACKPLATE ASSEM-
BLY until DIFFUSER rests in slot in support arm.
2. Secure DIFFUSER in position by tightening four DIFFUSER
MOUNTING SCREWS through holes in BACKPLATE ASSEM-
BLY against DIFFUSER. (Caution: Diffuser damage may occur;
do not over tighten diffuser mounting screws.)
CAUTION: MAXIMUM WATTAGE AS MARKED ON
FIXTURE MUST NOT BE EXCEEDED.
CAUTION: MAKE CERTAIN WIRES ARE NOT PINCHED
BETWEEN PARTS.
OUTLET BOX
WIRE NUT
GROUND WIRE
CROSS BAR
CROSS BAR
MOUNTING SCREW
OUTLET BOX SCREW
(PROVIDED WITH OUTLET BOX)
BATTERY NUT
SUPPORT ARM
SLOT
NOTCH
DIFFUSER
MOUNTING
SCREW
BACKPLATE
ASSEMBLY
DIFFUSER
WARNING: PUSH SUPPLY LEADS SECURELY INTO
JUNCTION BOX BEFORE PERMANENT
MOUNTING.
WARNING: FOR SUPPLY CONNECTIONS USE
WIRE RATED FOR AT LEAST 90˚C.
FIG. 1
WARNING: RISK OF FIRE. MOST DWELLINGS BUILT
BEFORE 1985 HAVE SUPPLY WIRE RATED 60˚C.
CONSULT A QUALIFIED ELECTRICIAN
BEFORE INSTALLING.
®