Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • H1108
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lytecaster®Recessed Downlighting 2000LV
Page 1 of 1 3 3/4 " Aperture Low Voltage MR16 Standard Frame-In Kit
11 1/8”
Features
1. Mounting Frame: .036" (#20 ga.) galvanized steel. Accommodates all
ceilings up to 1" thick. Push-in/twist-out rotoclips hold reflector flush to
ceiling.
2. Junction Box: 4" x 3 1/2”x 2", .063" (#14 ga.) galvanized steel. U.L. listed for
maximum of 8 No. 12 ga. 90° C through branch circuit conductors (75° C end
of run). Integral cable clamps permit attachment of nonmetallic Romex®or
armored cable without need of additional connectors.
3. Mounting Bars: .059" (#16 ga.) galvanized steel. 13" long bars extend
to 27" with integral nailing tabs. Attaches to wood joist without need of
accessories.
4. Socket Housing: Aluminum with lamp adjustment assembly allows 35°
max. vertical 358° horizontal adjustment. (See reflector trim specification
sheet for specific adjustment.)
5. Socket: Field replaceable. Two pin socket, pre-wired with #18 SF1 leads to
junction box.
6. Transformer: Outboard mounted, magnetic, 120V. primary, nominal 12V.
secondary. Removable from below.
7. Thermal Protector: Meets NEC and UL requirements. Insulation must be
kept 3" away from fixture sides and wiring compartments and must not be
placed above fixture in a manner which will entrap heat.
Dimming
Dimming Controls: use only dimmers specifically designed for use with magnetic
transformers, like Lightolier Onset® , Sunrise® series LV or VA dimmers, or any
Lightolier Controls dimming system. Low voltage fixtures may produce audible
sound when used with dimmers, which may be objectionable in acoustically criti-
cal areas.
Options & Accessories
Mounting Bars: 1964 - 20" set of (2)
T-Bar Ceiling Clips: 1956 - set of (4)
Plaster Ceiling Ring: 1959 - 7/8" depth for wet plaster ceilings.
MR16 Socket Replacement: 1975B
277V Remote Step-Down 7997 - 277V down to 120V
Transformer: 300W max. load.
Socket for General Electric Turn and Lock (TAL) MR16 Lamp: 1975TAL.
Labels
UL (Suitable for Damp Locations), I.B.E.W.
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit Reflector Trims — See Individual Reflector Trim Specification Sheets
Open Downlight Adjustable Enclosed
Aperture Cone Satin Cone Baffles Slot Pinhole Mini Swivel Eyeball Wet Location
2000LV 2012 2008 2005 2006 2011 2025WH 2022LV 2090LV
2012NM 2008NM 2005WH 2026WH
2013BKNM 2010 2005BNM
2013CD 2010NM 2005NM
2013CDNM
2013NM
2013BK
2013WH
2013
2013WD
2013WDP
Romex® is a registered trademark of General Cable Industries Inc.
