Lindy 70908 Installation instructions

70908
PCMCIA 32 bit
P&P
2P (ECP/EPP 32FIFO)
www.lindy.com

2
u DESCRIPTION:
The 70908 is 2 port Parallel PCMCIA card which equipped with two
ECP/EPP/SPP/BPP IEEE 1284c CENTRONICS Parallel Interface. The 70908
include two 25 pin female connector for peripherals’ units with IEEE 1284C
CENTRONICS Parallel Interface.
u Check your packing listing:
70908 Card
Print Cable 44PIN TO 25PIN*2 Female one set
Software Driver
Hardware Guide
Installation Guide
u Hardware Specification
Parallel Port:
Parallel Chipset: SUN1888, Hardware FIFO are 32Byte FIFO
Compatible chips: with ACC3203, ST-78C36, and HT6535.
IEEE standard: ECP/EPP/SPP/BPP (PS-II) Interface
Max. Speed: Up to 21.4MB/Sec
u Hardware installation guide:
½ Turn off the power of your computer
½ Plug-in the 70908 MIO Parallel Adapter to PCMCIA slot of your NOBOOK
½ Add-on the peripheral Printer, Modem, Scanner…etc. that you need to
this Adapter
½ Turn on the power of your computer
u TECHNICAL SPECIFICATION:
Compatibility: -CARD BUS 32Bit for
486/586/Pentium/Pentium-II/
P-III/C5/K6
Operating system: -WIN 2000,XP
Chips: -1 x SUN1888

3
Connections: - 44PIN TO 2 x 25 Pin D-SUB female
Connector parallel
PCB: - 2 Layer / 120 x 47 mm

4
This device complies with Part 15 of the FCC
Rules. Operation is subj
ect to the following two
conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operations.