Lindy 25046 User manual

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (Aug 2011)
For Home and Office Use
Tested to Comply with
FCC Standards
8 Port Gigabit Ethernet Switch
User Manual English
LINDY No. 25046
www.LINDY.com

Radio Frequency Energy, Certifications
Introduction
Congratulations on your purchase of this 10/100/1000Mbps gigabit switch. Instructions for
installing and configuring this product can be found in this manual. Before you install and use
this product, please read this manual carefully for full exploiting the functions of this product.
The Switch provides 10/100/1000Mbps Auto-Negotiation RJ45 ports. All RJ45 ports support the
Auto-MDI/MDIX function. Every port can work as uplink port or common port. Switch provides a
cost-effective, high performance, non-disruptive, smooth evolution into 1000M solutions. The
Switch delivers superior performance with improving workgroup, network bandwidth, increasing
network node, providing greater flexibility, installation convenience. It is the best choice for
increasing your speed.
1.1 Features
Compliance with IEEE802.3 、 IEEE 802.3u 、 IEEE 802.3ab standards
Supports IEEE802.3x flow control for Full Duplex mode and backpressure for half-duplex
mode
10/100/1000Mbps Auto-Negotiation RJ45 ports supporting Auto-MDI/MDIX
Supports MAC address auto-learning and auto-aging
Each port has independent bandwidth
LED indicators for monitoring power, link, activity
Plastic case, desktop or wall-mounting design
External Power Adapter supply
1.2 Environments
Operating Temperature : 0℃~40℃
Storage Temperature: -40℃~70℃
Operating Humidity: 10% ~90% RH Non-condensing
Storage Humidity: 5% ~90% RH Non-condensing
1.3 Package
One 10/100/1000Mbps gigabit switch
One User Manual
One Power Adapter
Installation
2.1 Front Panel LEDs
Power LED
This green indicator illuminates when the Switch is receiving power.

English Manual English 3
Port LED
These green indicators illuminate steadily when a port is connected to a station successfully, If
this green indicator is blinking, it indicates that a port is transmitting or receiving data on the
network.
2.2 Back Panel Features
The network ports and the power port are located on the back panel of the switch.
Ports
These ports are connection points for PCs and other network devices, such as additional
switches.
Power
The power port is where you will connect the included power adapter.
2.3 Connecting Network Devices
To connect network devices to the Switch, follow these instructions.
1. Make sure all the devices you will connect to the Switch are power off.
2. Connect a Category 5/5e Ethernet network cable to one of the numbered ports on the
Switch.
Note: Use Category 5e Ethernet network cables for your Gigabit connections.
3. Connect the other end to a PC or other network devices.
4. Repeat steps 2 and 3 to connect additional devices.
5. Connect the supplied power adapter to the power port on the Switch’s back panel.
Note: Make sure you use the power adapter apply to the Switch, using a different
power adapter may damage the Switch.
6. Plug the other end of the adapter into an electrical outlet.
7. Power on the devices connected to the Switch. Each active port corresponding LED will
light up on the Switch.

English Manual
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to cor

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the

Consult the dealer or an experienced technician for help
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
This device
complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause undesired operation
CE Statement, EMC Compatibilty
This device complies with EN Standards EN55022 and EN55024 according to the relevant EC EMC Directive. It
must be used with shielded cables only to maintain EMC compatibility.
Dieses Produkt entspricht den einschlägigen EMV
Kabeln verwendet werden.
LINDY Herstellergarantie
LINDY gewährt für dieses Produkt über die gesetzliche Regelung hinaus eine zweijährige Herstellergarantie ab
Kaufdatum. Die detaillierten Bedingungen dieser Garantie finden Sie auf der LINDY Website aufgelistet bei den
AGBs.
WEEE (Waste of Electrical a
nd Electronic Equipment),
Recycling of Electronic Products
In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical
and electronic equipment. The wheelie bin symbol shown indicates that this produ
household waste. Instead the product must be recycled in a manner that is environmentally friendly. For more
information on how to dispose of this product, please contact your local recycling centre or your household waste
d
isposal service. Each individual EU member state has implemented the WEEE regulations into national law in
slightly different ways. Please follow your national law when you want to dispose of any electrical or electronic
products.
More details can be obta
ined from your national WEEE recycling agency.
Germany / Deutschland
Die Europäische Union hat mit der WEEE Direktive umfassende Regelungen für die Verschrottung und das
Recycling von Elektro-
und Elektronikprodukten geschaffen. Diese wurden von der Bundes
und Elektronikgerätegesetz –
ElektroG in deutsches Recht umgesetzt. Dieses Gesetz verbietet vom 24.März 2006
an das Entsorgen von Elektro-
und Elektronikgeräten über die Hausmülltonne! Diese Geräte müssen den lokalen
Sammelsystemen b
zw. örtlichen Sammelstellen zugeführt werden! Dort werden sie kostenlos entgegen
genommen. Die Kosten für den weiteren Recyclingprozess übernimmt die Gesamtheit der Gerätehersteller.
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to cor
rect the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced technician for help
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation
CE Statement, EMC Compatibilty
This device complies with EN Standards EN55022 and EN55024 according to the relevant EC EMC Directive. It
must be used with shielded cables only to maintain EMC compatibility.
Dieses Produkt entspricht den einschlägigen EMV
Richtlinien der EU und darf nur zusammen mit abgeschirmten
LINDY gewährt für dieses Produkt über die gesetzliche Regelung hinaus eine zweijährige Herstellergarantie ab
Kaufdatum. Die detaillierten Bedingungen dieser Garantie finden Sie auf der LINDY Website aufgelistet bei den
nd Electronic Equipment),
Recycling of Electronic Products
In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical
and electronic equipment. The wheelie bin symbol shown indicates that this produ
ct must not be disposed of with
household waste. Instead the product must be recycled in a manner that is environmentally friendly. For more
information on how to dispose of this product, please contact your local recycling centre or your household waste
isposal service. Each individual EU member state has implemented the WEEE regulations into national law in
slightly different ways. Please follow your national law when you want to dispose of any electrical or electronic
ined from your national WEEE recycling agency.
Die Europäische Union hat mit der WEEE Direktive umfassende Regelungen für die Verschrottung und das
und Elektronikprodukten geschaffen. Diese wurden von der Bundes
ElektroG in deutsches Recht umgesetzt. Dieses Gesetz verbietet vom 24.März 2006
und Elektronikgeräten über die Hausmülltonne! Diese Geräte müssen den lokalen
zw. örtlichen Sammelstellen zugeführt werden! Dort werden sie kostenlos entgegen
genommen. Die Kosten für den weiteren Recyclingprozess übernimmt die Gesamtheit der Gerätehersteller.
1
English 4
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter
ference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
rect the interference by one or more of the following measures:
receiver is connected
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device must accept any interference received, including interference that may cause undesired operation
This device complies with EN Standards EN55022 and EN55024 according to the relevant EC EMC Directive. It
Richtlinien der EU und darf nur zusammen mit abgeschirmten
LINDY gewährt für dieses Produkt über die gesetzliche Regelung hinaus eine zweijährige Herstellergarantie ab
Kaufdatum. Die detaillierten Bedingungen dieser Garantie finden Sie auf der LINDY Website aufgelistet bei den
In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical
ct must not be disposed of with
household waste. Instead the product must be recycled in a manner that is environmentally friendly. For more
information on how to dispose of this product, please contact your local recycling centre or your household waste
isposal service. Each individual EU member state has implemented the WEEE regulations into national law in
slightly different ways. Please follow your national law when you want to dispose of any electrical or electronic
Die Europäische Union hat mit der WEEE Direktive umfassende Regelungen für die Verschrottung und das
und Elektronikprodukten geschaffen. Diese wurden von der Bundes
regierung im Elektro-
ElektroG in deutsches Recht umgesetzt. Dieses Gesetz verbietet vom 24.März 2006
und Elektronikgeräten über die Hausmülltonne! Diese Geräte müssen den lokalen
zw. örtlichen Sammelstellen zugeführt werden! Dort werden sie kostenlos entgegen
genommen. Die Kosten für den weiteren Recyclingprozess übernimmt die Gesamtheit der Gerätehersteller.
LINDY No. 25046
1
st
Edition, August 2011
www.lindy.com