Linksys VGA2000 User manual

Linksys One Voice Gateway
QUICK INSTALLATION GUIDE
Model VGA2000

Linksys One VGA2000 Voice Gateway

Linksys One VGA2000 Voice Gateway
137577
SYSTEM LINE PHONE LAN RESET
Phone
cable
Ethernet
cable
TM
SYSTEMLINEPHONELANRESET
TM
Linksys
®
OneIP Phone
QUICKINST
ALLA
TIONGUIDE
Model PHM1200
Voice Gateway Model VGA2000

Linksys One VGA2000 Voice Gateway
LAN USB PHONE LINE
137578
OR
SYSTEM LINE PHONE LAN RESET
1

Linksys One VGA2000 Voice Gateway
LAN USB PHONE LINE
137581
Ethernet cable
2

Linksys One VGA2000 Voice Gateway
PHONE LINE
LAN USB PHONE LINE
137580
Phone cable
3

Linksys One VGA2000 Voice Gateway
LAN USB PHONE LINE
137579
PHONE LINE
Or
4

Linksys One VGA2000 Voice Gateway
The Linksys One VGA2000 Voice Gateway meets the following regulatory compliance and safety standards:
Specification Description
Regulatory Compliance Products with the CE Marking indicate compliance with the 1999/5/EEC directives, which includes the
following safety and EMC standards:
Safety UL 60950
CSA-C22.2 No. 60950
EN 60950
IEC 60950
EMC FCC Part 15 (CFR 47) Class B
ICES-003 Class B
EN55022 Class B
CISPR22 Class B
EN55024
EN50082-1
EN 61000-3-2
EN 61000-3-3
EN 61000-6-1
VGA2000 Voice Gateway Regulatory Compliance and
Safety Information

Linksys One VGA2000 Voice Gateway
FCC Part 15 Class B Compliance
This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Part 15 - Radio Frequency Devices
This device complies with FCC Part 15B. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference that may cause undesired operation.
Canada Class B Notice
The Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulation. Cet appareil numerique de la
class B respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada.

Linksys One VGA2000 Voice Gateway
FCC Part 68 Compliance
This equipment complies with Part 68 of FCC Rules. On the bass unit of this equipment is a label that contains, among other information, the FCC
Registration Number and Ringer Equivalence Number (REN) for this equipment. IF REQUESTED, THIS INFORMATION MUST BE GIVEN TO THE
TELEPHONE COMPANY.
The REN is useful to determine the quantity of devices you may connect to your telephone line and still have those entire devices ring when your
telephone number is called. In most, but not all areas, the sum of the REN of all devices connected to one line should not exceed five (5.0). To be
certain of the number of devices you may connect to you line, as determined by the REN, you should contact your local telephone company to
determine the maximum REN for your calling area.
If your equipment causes harm to the telephone network, the telephone company may discontinue your service temporarily. If possible, they will
notify you in advance. But if advance notice is not practical, you will be notified as soon as possible. You will be informed of your right to file a
complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the
proper functioning of your equipment. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone
service.
If you experience trouble with this telephone equipment, please contact the following address and phone number for information on obtaining
service or repairs. The telephone company may ask that you disconnect this equipment from the network until the problem has been corrected or
until you are sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs.
Company: Cisco-Linksys LLC
Address: 121 Theory Drive Irvine, CA 92617 (USA)
Tel no.: 949-823-3188

Linksys One VGA2000 Voice Gateway
Canada IC CS-03 REN (Ringer Equivalent Numbers) Statement
NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices
subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.
Attachment Limitations Statement
NOTICE: This equipment meets telecommunications network protective, operational and safety requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements document(s). This is confirmed by marking the equipment with the Industry Canada certification
number. The Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications
company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance
with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic
water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
Caution Users should not attempt to make such connections themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.'

Linksys One VGA2000 Voice Gateway
Safety Information
The following statements are warnings or safety guidelines. A warning means danger. You are in a situation that could cause bodily injury. Before
working on equipment, be aware of the hazards involved with electrical circuitry and standard safety practices to prevent accidents.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each
warning to locate its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
FCC Part 15 Class B Warning
A shielded-type power cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that only the supplied power
cord be used. Use only shielded cables to connect I/O devices to this equipment. You are cautioned
that changes or modifications not expressly approved by the party responsible for compliance could
void your authority to operate the equipment.

Linksys One VGA2000 Voice Gateway
Warning
Work During Lightning Activity
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Installation Instructions
Read the installation instructions before connecting the system to the power source.
Warning
SELV Circuit
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.

Linksys One VGA2000 Voice Gateway
Caution Inline power circuits provide current through the communication cable. Use the Linksys-provided cable or a minimum
24AWG communication cable.
Warning
Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Comply with Local National Electrical Codes
Installation of the equipment must comply with local and national electrical codes.
Warning
Product Disposal
Ultimate disposal of this product should be handled according to all national laws and regulations.

Linksys One VGA2000 Voice Gateway
Power Supply Safety Warnings
When using the VGA2000 Voice Gateway with the optional external power supply, observe the following safety warnings:
Warning
TN Power
The device is designed to work with TN power systems.
Warning
Ground Conductor Warning
Never defeat the ground conductor or operate the equipment in the absence of a suitably installed
ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are
uncertain that suitable grounding is available.
Warning
Power Supply Installation Warning
The power supply must be placed indoors.

Linksys One VGA2000 Voice Gateway
Caution Only use the Linksys-specified power supply. Refer to the installation manual provided with this product.
Warning
Circuit Breaker
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than: 120 VAC, 15A U.S. (240 VAC, 10A international)
Warning
Main Disconnecting Device
The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device.

Linksys One VGA2000 Voice Gateway
Linksys Software License Agreement v.2.14.05
THIS LICENSE AGREEMENT IS BETWEEN YOU AND CISCO-LINKSYS LLC ("Linksys"). BY DOWNLOADING OR INSTALLING THE
SOFTWARE, OR USING THE PRODUCT CONTAINING THE SOFTWARE, YOU ARE CONSENTING TO BE BOUND BY THIS
AGREEMENT. IF YOU DO NOT AGREE TO ALL OF THESE TERMS, THEN YOU MAY NOT DOWNLOAD, INSTALL OR USE THE
SOFTWARE. YOU MAY RETURN UNUSED SOFTWARE (OR, IF THE SOFTWARE IS SUPPLIED AS PART OF ANOTHER PRODUCT,
THE UNUSED PRODUCT) FOR A FULL REFUND UP TO 30 DAYS AFTER ORIGINAL PURCHASE, SUBJECT TO THE RETURN
PROCESS AND POLICIES OF THE PARTY FROM WHICH YOU PURCHASED SUCH PRODUCT OR SOFTWARE.
License. Subject to the terms and conditions of this Agreement, Linksys grants the original end user purchaser of the Linksys product
containing the Software ("You") a nonexclusive license to use the Software solely as embedded in or (where authorized in the applicable
documentation) for communication with such product. This license may not be sublicensed, and is not transferable except to a person or entity
to whom you transfer ownership of the complete Linksys product containing the Software, provided you permanently transfer all rights under
this Agreement and do not retain any full or partial copies of the Software, and the recipient agrees to the terms of this Agreement.
"Software" includes, and this Agreement will apply to (a) the Linksys software provided in or with the applicable Linksys product, and (b) any
upgrades, updates, bug fixes or modified versions ("Upgrades") or backup copies of the Software supplied to You by Linksys or an authorized
reseller, provided you already hold a valid license to the original software and have paid any applicable fee for the Upgrade.
Protection of Information. The Software and documentation contain trade secrets and/or copyrighted materials of Linksys or its suppliers.
You will not decompile, decrypt, reverse engineer or disassemble the Software (except to the extent expressly permitted by law
notwithstanding this provision), and will not disclose or make available such trade secrets or copyrighted material in any form to any third party.
Title to Software and documentation will remain solely with Linksys.
Open Source Software. The GPL source code incorporated into the Software is available for free download at http://www.linksys.com/gpl. If
You would like a copy of the GPL source code in this Software on a CD, Linksys will mail to You a CD with such code for $9.99 plus the cost of
shipping upon request.
Term and Termination. You may terminate this License at any time by destroying all copies of the Software and documentation. Your rights
under this License will terminate immediately without notice from Linksys if You fail to comply with any provision of this Agreement.

©2005 Cisco Systems, Inc. All rights reserved. Linksys is a registered trademark and the Linksys One logo is a trademark of Cisco Systems, Inc.