Lippert TI-465 User manual

Rev: 02.23.2023 Page 1 CCD-0007287
ADVANTAGE LEVELING CONTROLLER
RESET PROCEDURE
TI-465
LEVELING AND STABILIZATION
Purpose
This document outlines the procedure for resetting an Advantage leveling controller for use with a different
user interface touch pad.
Procedure
Changing From LCD to LED Touch Pad
1. Using the LCD touch pad (Fig. 1), set the zero point five times in a row.
A. With the LCD touch pad turned off, press the front button (Fig. 1A) five times and the rear button
(Fig. 1B) five times. The touch pad will beep and display "Zero Point Calibration, Press Enter to Set".
B. Press the enter button (Fig. 1C) to set the zero point. The LCD touch pad will beep and the display
will return to normal operation mode.
C. Repeat steps A and B four more times.
Fig. 1
2. Disconnect power from the leveling controller.
3. Remove the harness from the four pin receptacle on the back of the LCD touch pad (Fig. 2A) and insert
it into the 4 pin receptacle on the back of the LED touch pad (Fig. 4A).
4. Reconnect power to the leveling controller.
5. The LED controller (Fig. 3) is now ready to use.
A
B
C
Fig. 2
A

Rev: 02.23.2023 Page 2 CCD-0007287
TI-465
LEVELING AND STABILIZATION
ADVANTAGE LEVELING CONTROLLER
RESET PROCEDURE
As a supplier of a broad array of highly-engineered components in the recreation and transportation product markets, safety, education and customer satisfaction are
our primary concerns. Should you have any questions, please do not hesitate to contact us at 432-LIPPERT (432-547-7378) or by email at [email protected] .
Self-help tips, technical documents, product videos and a training class schedule are available at lippert.com or by downloading the LippertNOW app.
Changing From LED to LCD Touch Pad
1. Using the LED touch pad, set the zero point five times in a row.
A. With the LED touch pad turned off, press the FRONT button (Fig. 3A) five times and the REAR
button (Fig. 3B) five times. The touch pad will beep and all of the LED lights will flash.
B. Press the ALL JACKS (Fig. 3C) and AUTO (Fig. 3D) buttons at the same time to set the zero point.
The WAIT LED (Fig. 3E) will flash a few times, and then the touch pad will return to normal
operation mode.
C. Repeat steps A and B four more times.
2. Disconnect power from the leveling controller.
3. Remove the harness from the four pin receptacle on the back of the LED touch pad (Fig. 4A) and insert
it into the 4 pin receptacle on the back of the LCD touch pad (Fig. 2A).
4. Reconnect power to the leveling controller.
5. The LCD controller (Fig. 1) is now ready to use.
Fig. 3
A
B
Fig. 4
C
C
E
A