Little Giant Ladder 31408 User manual

READ THESE INSTRUCTIONS COMPLETELY BEFORE YOU START. IF YOU DON’T
UNDERSTAND THESE INSTRUCTIONS, PLEASE CALL 800-453-1192 FOR ASSISTANCE
1. Failure to comply with all instructions may result in serious injury.
2. Make sure this kit is compatible with your ladder. If you have any questions concerning
the use of this kit on Little Giant Ladder Systems products, call 800-453-1192 for
assistance.
3. Before installing this kit, identify all kit components. If any components are missing or
damaged, please contact Customer Care. Do not substitute any components.
4. Inspect the ladder before installing this kit. Repair or replace any damaged or missing
ladder parts before using the ladder. Use only Little Giant Ladder Systems repair or
replacement parts. If you are unable to repair it, discard the ladder.
COMPONENTS IN KIT TOOLS NEEDED
NOTE: IF ANY OTHER PART OF THE LADDER IS DAMAGED BEFORE OR DURING
THE PROCESS OF INSTALLING AND/OR REPAIRING, DISCARD THE LADDER OR
CONTACT CUSTOMER CARE FOR INSTRUCTIONS.
DO NOT USE A DAMAGED LADDER!
57774 v1 1.15 (1)
Procedure for installing the Fixed Foot on Little Giant Ladder Systems Extension ladders.
Fixed Foot
Replacement
(2) 9/16”Wrench
(1) Fixed Foot
(2) Hex Head Bolt
(2) Center Nut
(4) 3/8”Washer

57774 v1 1.15 (2)
1. Identify the feet that you will be replacing on your
extension ladder.
2. Lay the ladder on its face to make the following
steps easier.
3. Using (2) 9/16” wrenches, loosen and remove the
(2) washers, bolt and nut that are holding the (exist-
ing) foot in place.
4. Remove (existing) foot.
5. Remove the (existing) spacers from the internal
foot bracket
6. Repeat steps 3-5 on the adjacent foot.
9/16”Wrench
9/16”Wrench

57774 v1 1.15 (3)
7. Once both feet have been removed, insert the
(new) fixed foot onto the ladder.
8. Make sure that the picked plate on the foot is
facing (down) or the back of the ladder. (As shown
in the illustration.
9. Insert the (new) bolt, washers and nut onto and
through the (new) fixed foot, as shown in the illustra-
tion.
10. Tighten using (2) 9/16” wrenches.
11. Repeat steps 9 and 10 on the adjacent foot. 12. Once all of the steps have been completed,
rotate the (new) fixed foot to make sure it rotates
freely.
9/16”Wrench
9/16”Wrench
Side View
Top View