Little Giant Ladder KIT 31006 User manual

LOCK TAB REPLACEMENT
READ THESE INSTRUCTIONS COMPLETELY BEFORE YOU START. IF YOU DON’T
UNDERSTAND THESE INSTRUCTIONS, PLEASE CALL 800-453-1192 FOR ASSISTANCE
Procedure for replacing the lock tab on Little Giant Ladder Systems Type I, MegaLite,
MegaMax, Titan, Titan X ladders.
1. Failure to comply with all instructions may result in serious injury.
2. Make sure this kit is compatible with your ladder. If you have any questions concerning
the use of this kit on Little Giant Ladder Systems products, call 800-453-1192 for
assistance.
3. Before installing this kit, identify all kit components. If any components are missing or
damaged, please contact Customer Care. Do not substitute any components.
4. Inspect the ladder before installing this kit. Repair or replace any damaged or missing
ladder parts before using the ladder. Use only Little Giant Ladder Systems repair or
replacement parts. If you are unable to repair it, discard the ladder.
COMPONENTS IN KIT 31006 TOOLS NEEDED
53097 v2 4.14 (1)
(1) Lock Tab Assembly
(1) Slotted Rung Cap
Hammer
Chisel
NOTE: IF ANY OTHER PART OF THE LADDER IS DAMAGED BEFORE OR DURING
THE PROCESS OF INSTALLING AND/OR REPAIRING, DISCARD THE LADDER OR
CONTACT CUSTOMER CARE FOR INSTRUCTIONS.
DO NOT USE A DAMAGED LADDER!

53097 v2 4.14 (2)
1. Locate the lock tab on the outer assembly that needs to be
replaced.
2. Remove the outer assembly from the inner assembly.
6. Insert the new lock tab (included in kit) into the rung.
3. Lift the rung cap o the rung. *If unable to do so see step 5. 4. With chisel and hammer, tap the rung cap free of the rung
making sure the chisel is parallel to the rung as not to damage
the rung (as shown in illustration). Discard the damaged rung
cap.
5. Pull the lock tab free of the rung, and discard.

53097 v2 4.14 (3)
7. Push down slotted rung cap onto the lock tab. Line up the
post with the hole in the rung.
9. Make sure that the rung cap and lock tab are secure before
re-installing the outer assembly onto the inner assembly.
8. Use a hammer to tap the post on the rung cap into the rung
hole. TAKE CARE NOT TO DENT RUNG.
10. Re-insert the outer assembly onto the inner assembly.