Little Giant Ladder WingSpan Wall Stand Off User manual

Swing the clamp around and hook it into
the open slot in the rung bracket, then
tighten the clamp onto the rung. If the
clamp will not reach the slot, loosen the
clamp all the way, and then try again.
Make sure the WingSpanTM is secure
before each use.
®
INSTRUCTIONS
To assemble, hold down the spring pins
and slide the arms into the rung bracket
until the spring pins lock into place.
Make sure the clamp is swung out of the
way, and the outer assembly on the
ladder is extended at least one rung.
Slide the rung bracket onto the top outer
rung as shown above. The rung bracket
should sit at 90 degree angle as shown
in the image below.
Rung bracket
Clamp
Spring pin
Arms
Your WingSpan wall standoff is now
ready to use
If you need any assistance with these instructions,
please call our Customer Experience Team at
800-453-1192.
Components
Correct
Incorrect
shown without arms

®
INSTRUCTIONS
©2023 Little Giant Ladder Systems, LLC. 51246 v5 11.23
www.LittleGiantLadders.com
Little Giant Ladder Systems, LLC.
1198 North Spring Creek Place
Springville, UT 84663
Toll Free: 800-453-1192
Phone: [phone]
Fax: [phone]
Do not rest arms on roof
Do not rest on rain gutters
Do not use on uneven or
sloped surfaces
Always keep arms
perpendicular to
wall/Surface
Make sure ladder is
properly set up on
an even surface
75.5°
WARNING: Use only in approved positions.
Use in any other positions may result in serious injury or death.