Living Spaces 85PHRL User manual

C2
D2
C1
(Red Tape)
D1
(Red Tape)
P
A
B
2. Locate the power cords C1 and C2
attached to the seat back and the power
cords D1 and D2 at the rear of the seat base.
Connect C1 to D1 and C2 to D2. C1 and D1
can be identified by the red tape.
1. Slide the metal receiver over the
metal post.Press both sides of back
firmly downward until locked in place.
Assembly Instructions for OPTIONS - 85PHRL
A
B
C
D
3. The Transfomer P is attached to the
bottom of rail and connect to DC Port
located at the rear of arm.
Male
5. KD Wings (If applicable)
Insert the male KD Bracket into the slot of
the female Bracket pressing firmly
Female
4. The table is
located inside the
black dust cover
under the RAF Arm.
Please remove it
and place into the
Circular metal base.
Note:
Make sure all PLUGS are connected on the product before plugging power cord
into power outlet. If not damage can occur.
The USB ports (where applicable) are designed with working voltage of 5V, and
can NOT be used to supply power for laptop computers (neither PC or Mac).
Plugging a laptop computer to the USB port may end up damaging either the
computer or the USB port due to unmatched working voltage.