Living Spaces Olivia Queen User manual

CONGRATULATIONS ON YOUR NEW BED PURCHASE
~Warning：do not move bed after final assembly as it may result in damages to floor and/or bed.~
Hardware Diagram includes factory installed bolts and washers.
1 2 3
Step#1
Retrieve bed feet from carton fastened behind the headboard.
Attach bed feet (F) to the headboard using Wrench (I), Bolt (R) and Washer (E).
Step#2
Attach bed feet (F) to the footboard using Wrench (I), Bolt (R) and Washer (E).
Step#3
Attach side rails to headboard and footboard using Wrench(I), Bolt (B) and Washer (E)
(factory installed).
A B D E F G I J R T
Φ6*15MM Φ8*30MM Φ6 MM Φ8 MM H=10 CM Metal Slats Φ8 MM Center support legs Φ8*70MM Φ6*20MM
8PCS 8PCS 12PCS 8PCS 4PCS 4PCS 1PC 4PCS 4PCS 4PCS
Olivia Queen Assembly instructions

CONGRATULATIONS ON YOUR NEW BED PURCHASE
~Warning：do not move bed after final assembly as it may result in damages to floor and/or bed.~
Hardware Diagram includes factory installed bolts and washers.
4 5
Step#4
Attach steel center support legs (J) to the Metal slat (G) using Wrench (I), Bolt (T) and
Washer (D).
Step#5
Move/place bed into final position in bedroom.
Attach steel slat support system to full length steel side support cleats(flat side facing up).
Verify the metal slats are installed properly into support cleats and center support legs are
perpendicular to the floor for full support.
A B D E F G I J R T
Φ6*15MM Φ8*30MM Φ6 MM Φ8 MM H=10 CM Metal Slats Φ8 MM Center support legs Φ8*70MM Φ6*20MM
8PCS 8PCS 12PCS 8PCS 4PCS 4PCS 1PC 4PCS 4PCS 4PCS
Olivia
Q
ueen Assembl
y
instructions