Living Spaces Sedona 7030-01245 KIT User manual

Sedona Collection: Wrangler Bunk
PARTS LIST
BOX 1: 4710 Wrangler Bunk Ends
Part # Description Quantity
S0003END Wrangler Bunk Top End 2
S0007END Wrangler Bunk Bottom End
2
BOX 2: Wrangler Bunk Frame
Part # Description Quantity
S1002SRL 5/4x8 Matress Rail 4
560750001 5/4x6 Guard Rail
2
149383/40 Individual Twin Slat 3
FLDWL 3" Fluted Dowel 4
5040-43181 Hex Lag Bolt/Washer 24
5040-35410 #6 x 1 1/4 Phil Flat Slat Screw 20
Picture
Picture
7030-01245 KIT
For: 4710 Frame Rails/4711 Bunk Ends
COMPLETED ASSEMBLY

5040-43181
560750001
S0003END
S1002SRL
S0007END
FLDWL

00700
SAFETY WARNING
Our Bunk Beds have been tested by an Independent Laboratory and are certified to be in compliance with:
ASTM F-1427, “Standard Consumer Safety Specification for Bunk Beds” and U.S. Government
specifications 16 Code of Federal Regulations, parts 1213 and 1513.
SAFETY WARNINGS
1. Follow the information on the warnings attached to the upper bunk end structure and on the carton. Do
not remove this label.
2. Always use the recommended size mattress or mattress support, or both, to help prevent the
likelihood of entrapment or falls.
3. Surface of mattress must be at least five inches(127mm) below the upper edge of guardrails.
4. Do not allow children less than six years of age to use the upper bunk.
5. Periodically, check and ensure that the guardrail, ladder and other components are in their proper
position, free from damage and that all connectors are tight.
6. Do not allow horseplay on or under the bed and prohibit jumping on the bed.
7. Prohibit more than one person on upper bunk.
8. Always use the ladder or bed end for entering and leaving the upper bunk.
9. Do not use substitute parts. Contact manufacturer or dealer for replacement parts.
10. Use of a night-light may provide added safety precautions for a child using the upper bunk.
11. If the bunk bed will be placed next to a wall, the guardrail that runs the full length of the bed should be
placed against the wall to prevent entrapment between the bed and the wall. (This applies only to bunk
beds without two full-length guardrails.)
12. Always use guardrails on both long sides of the upper bunk.
13. The use of water or sleep flotation mattress is prohibited.
14. Keep these instructions for future reference.
STRANGULATION HAZARD
15. Never attach or hang items to any part of the bunk bed that are not designed for use with the bed for
example, but not limited to hooks, belts and jump ropes.
SIZE OF UPPER AND LOWER MATTRESS AND FOUNDATION
Your Twin bed is designed to use a mattress 37”-39” in width and 74” - 75” in length.
Your Full bed is designed to use a mattress 52”-54” in width and 74” - 75” in length.
The total thickness of mattress and foundation (slat kit, bunk board, etc.) combined must not exceed 7”.
Note: There must be at least 5” from mattress sleeping surface to top edge of guardrail.
REPLACEMENT PARTS
Replacement parts, including additional guardrails, maybe obtained from your Furniture dealer.
4706, 4711, 4721, 4731, 4738, 4743UPDATED: 06/08/2016
* A FOUNDATION IS REQUIRED WITH 3 SLAT CONFIGURATION *

Installation of individual slats for use with Slat Roll (Slat roll sold separately) See your retailer for purchase of Slat Roll
SCREW
SCREW
SCREW
SCREW SCREW SCREW SCREW
SCREW
SCREW
SCREW
INDIVIDUAL SLATS INDIVIDUAL SLATS INDIVIDUAL SLATS
Installation of individual slats for use with Bunkie Board (Bunkie Board sold separately) See your retailer for purchase of Bunkie Board
SCREWSSCREWSSCREWSSCREWSSCREWSSCREWS
INDIVIDUAL SLATS INDIVIDUAL SLATS INDIVIDUAL SLATS
When used with a slat roll, the three
individual slats should be placed evenly in the gaps and underneath the strapping before fastening.
Individual Slat
Individual Slat
Individual Slat
Diagram 1 Diagram 2
Scan Code for Instructional video

STAIRWAY /BUNK 7030-00420
STAIRWAY CHEST WITH BUNK BED
 

 

 


 
 

 
4453 / 4493 / 4676
 N  N  30  M  N 

THE DRAWERS OF YOU STAIRWAY CHEST HAVE BEEN SECURED FOR
SHIPPING WITH SECURITY STRIPS. TO RELEASE THESE STRIPS PULL EACH
DRAWER FIRMLY OUT UNTIL YOU FEEL THE STRIP RELEASE. EACH DRAWER
WILL FUNCTION PROPERLY AFTER THE FIRST TIME YOU PULL THEM OUT.
THERE IS NO NEED TO ATTEMPT TO REMOVE THE SAFETY STRIPS AS THEY
WILL NOT INTERFER WITH THE PROPER USE OF EACH DRAWER.
4453 / 4493 / 4676 STAIRWAY CHEST
4493
Sedona
Jr. Stairway Chest
4453
Sedona
Stairway Chest
4676
Summit
Stairway Chest