LMI Technologies HDI 109 User manual

Quick Start Guide
15219-1.0_MANUAL_Quickstart-HDI-109-OEM.pdf
109 OEM Scanner

Getting Started with the HDI 109 OEM 3D Scanner
Congratulations on purchasing the HDI 109 OEM 3D Scanner. This quick start guide provides you with
the resources to get you started on 3D scanning.
The HDI 109 OEM 3D Scanner comes with:
• 3D scanning software, FlexScan3D
• Physical capturing unit for capturing 3D data (some assembly is required)
Downloading FlexScan3D Software
The HDI 100 Series 3D Scanner is powered by FlexScan3D. You can download the software from
the Download Center (downloads.lmi3d.com). To create a download account, please send your
contact name, email address, company name, and scanner model to [e-mail].
Instructions for installing and activating FlexScan3D using installation ID or dongle can be found in
the FlexScan3D User’s Guide under “Getting Started”: http://manual.lmi3d.com.
Assembling the Capturing Unit
Instructions for assembly can be found in this Quick Start Guide.
Customer Support
If you have any installation issues, please contact:
Worldwide Email:
[e-mail]
Web:
www.lmi3D.com
North America Phone:
[phone]
Europe Phone:
[phone]

Hardware Included with Your HDI 109 OEM Scanner
NOTE: Refer to the FlexScan3D User’s Guide for information on installing and using the
FlexScan3D software at http://manual.lmi3d.com.
When you receive your HDI 109 OEM 3D Scanner, check that these items are included:
HDI 109 OEM Scanner, Blue LED
Connector

Mount the Scanner
• Use four M5 x 0.8 screws of suitable length. The recommended thread engagement into the
housing is 8 - 10 mm.
Prepare a Power Cable
• You must prepare a power cable using the provided connector. Refer to the table and diagram
below for pin information.
Function Pin
DC_12V 1
1 2
View: Looking into connector on the scanner
GND_12V 2

Plug the Prepared Power Cable into the Scanner
Plug an Ethernet Cable into the Scanner
• Use a Cat5e Ethernet cable.

Power Up the Scanner
• Apply power to the scanner.
The Power indicator should light when you apply
power.
(Consult the User Manual for troubleshooting tips if the
indicator does not light.)
Connect to Your Computer
• Connect the Ethernet cable to a free Ethernet port on your computer.

LMI Technologies, their partners, and resellers accept no liability for any damages (personal or to property) incurred as a result
of improper use, incorrect assembly, failure to adhere to safety precautions, and/or mistreatment of this product (including its
components).
The physical assembly of the HDI 109 OEM 3D Scanner is now
complete.
Next Steps - Installing FlexScan3D
NOTE: Please refer to FlexScan3D User’s Guide for information on installing and using the
Flexscan3D software at http://manual.lmi3d.com.

Copyright © 2015 LMI Technologies Inc. All rights reserved.