Loll Designs AC-RS-CG User manual

Use a branch at least 4˝ in diameter on a healthy/sturdy
tree and tall enough to allow full motion of the swing
(see reverse side for more details).
1 Drill two holes through the center of the branch 20
inches apart and the same diameter as the eye bolt
shank. Insert the eye bolt through the hole and t the
large washer and locking nut over threads. Tighten nut
down securely.
2 Place quick links through the eye bolts and leave
3-4 Fit the rope rings into the quick links and thread the
quick links shut. 5-6 Check the swing seat for distance
from the ground and that it hangs level. Use a level on
the swing seat for best measurement. If the seat does
not hang level, one end is too short and rust resistant
chain links can be added to correct length to level the
seat.
*Note: 7-8 If chain links are required an additional quick
link will be required to connect the chain to the rope
loop.
INSTALL EYE BOLT
ATTACH CHAIN/ROPE
1
3
5
7
2
4
6
8
ROPE SWING
SWING HANGING SUGGESTIONS
lolldesigns.com 1-877-740-3387

Swing Seat height from the ground
should be approximately 18˝. Check
the swing seat for distance from the
ground and that it hangs level.
Use a level on the swing seat for best
measurement.
Chain if neccessary to level swing seat
and adjust height from ground.
Rope ring
Rope: 5 ft. (included)
Hardware
*not included
Quick link to attach ring/chain to eye bolt.
Drill holes
Washer 2
Eye bolt 2
Quick Link 2-4
Chain
as required
2
Locking Nut 2
Qty.
Tree branch should be at least 4˝
diameter in healthy/sturdy tree.
ROPE SWING
SWING HANGING SUGGESTIONS
lolldesigns.com 1-877-740-3387