Shows
Low Batt
:
on display when batteries needs to
be r eplaced. Use 6 Alkaline AA cells
Low Battery indication has 2 steps:
1) LOW BATT CHANGE SOONLOW BATT CHANGE SOON
LOW BATT CHANGE SOONLOW BATT CHANGE SOON
LOW BATT CHANGE SOON
comes on when you have approx. 4 hours
left - plenty of time.
2) LOW BATTLOW BATT
LOW BATTLOW BATT
LOW BATT CHANGE NOWCHANGE NOW
CHANGE NOWCHANGE NOW
CHANGE NOW
comes when you have approx.
1/2 hour left.
NOTE: THIS MODEL DOES NOT USE
RECHARGABLE BATTERIES.
Power consumption is so low that
it only needs battery replacement about
once a year or less.
Instructions for Model No. 72601, 72609, & 72628 Scales
• Control box shuts off after 1+ hour. Push ON/OffON/Off
ON/OffON/Off
ON/Offto turn back on (DO NOT re-zero unless car is off pads)
• If you turn off just the control box after 1 minute pads go into "standby" mode. If control box is turned back
on within 1 hour pads will go back to active. If the green LED is out you will need to turn the pads back on also.
• Keep the system clean and dry. Do not drop either the pads or the control box.
Call, FAX, e-mail
if you have any questions or problems.
Memory:
To store weights in
Memory push & hold
Memory Store
button, then push #1 - 8.
To recall push and hold
#1 - 8 only.
2/12
Zero:
Push BEFORE putting
car on scales.
DON'T push Zero
AFTER car is on scales.
This defines zero
weight.
"2ero" on display
indicates zero has been
lost. Remove weight &
rezero.
1) Set up pads along side car. Scale pads are marked RF, LR, etc. and should be used at that location.
2) Set up control box in a convenient location and connect cables to the pads. Cables are marked and must be used for that pad.
3) Turn on control box, allow to warm up for a minute or so.
4) Push Zero. This defines "0" weight. DON'T PUSH Zero AFTER CAR IS ON SCALES.
5) Lift car and place pads under wheels. "Shake" car up & down at each corner to settle out any shock or suspension friction.
Customize 4 line
display:
To change the 4 line % display to
your preference push CHANGE
DISPLAY and hold for 5 sec. Top
line will start to flash. Use arrows to
scroll up or down to the % you want
on that line. Push CONTINUE. The
second line starts to flash. Use
arrows to select this line. Press
CONTINUE after each selection.
Normal function resumes after last
selection or push ON. This will stay
until you change.
Longacre Racing Products, Inc.
16892 146th St SE, Monroe, Wa. 98272
Ph (360) 453 2030 FAX (360) 453 2031
www.longacreracing.com
To CHANGE BATTERIES: Control Box:
Remove 4 small screws in the plate on the
bottom of the black enclosure - marked
“Batteries”. Replace with 6 quality AA
alkaline batteries (always replace all
batteries). Be sure polarity is correct. The
coil spring goes to negative end.
CAPACITY:
Most #s listed: 1500 lb (650 kgm)
per pad.
#72628 kart scale: Do NOT
exceed 400 lbs. (180 kgm)
Excess weight can damage
the load cells.
Metric:
See below
System can be set for Metric readout. See below.
