Lorex Add-On Camera LW2451AC1 User manual

FOR MORE INFORMATION:
www.lorextechnology.com
LW2451AC1 QSG_EN_R1 Page 1
Contents:
Before you install the camera, carefully plan where and how it will be positioned,
and where you will route the cable that connects the camera to the power adaptor.
Avoid installing in a location which requires the wireless signal to pass through
cement, concrete and metal structures. This will reduce the transmission range.
TIP
1. Connect the Power Adaptor to the 5V Input on the back
of the camera.
2. Connect the power adapter to a power outlet.
3. Slide the power switch to the ON position.
Powering the Camera
Pairing the Camera
NOTE:
• Only use the included power adapter to power the camera(s).
Place the camera and video monitor 12 inches apart.
Turn on the camera first and then the video monitor.
1
Press the Menu button on the monitor, then select
Pairing and press the OK button.
2
Select an available channel, and press the OK button.
NOTE: By default, the camera included with the
system is paired to channel 1.
3
You should immediately see video from the camera on
the video monitor.
Use a pen or paperclip to press the Pair button on
the side of the camera within 30 seconds.
4
NOTE:
• To pair multiple cameras, repeat steps 2~4,
selecting a different channel in the pairing menu.
• You can add a maximum of four (4) wireless
cameras to the video monitor.
Camera Power Adapter
Security Clips
SIMPLY AWARE™
LW2451AC1
ADD-ON CAMERA
Quick Start Guide
Pair Button
Use a pen or paper clip
to press the Pair button
during the pairing process
with the video monitor.
1 2 3
3
4