5756 English
• UnbalancedHeadphoneOutput(3.5mm)
• BalancedLineOutput(4.4mm)
• UnbalancedLineOutput(3.5mm)
FreqResponse +0.005/-0.259dB (20~20kHz)
THD+N 0.00025%@1kHz(20~20kHz,A-weight,Noload)
SNR 121dB(20~20kHz,A-weight)
OutputLevel +12dBu(High Gain) -5.6dBu(Low Gain)
Dynamic Range 122dB@1kHz(20~20kHz,A-weight)
NoiseLevel -118dBu
Crosstalk -120dB
FreqResponse +0.004/-0.254 dB (20~20kHz)
THD+N 0.00022%@1kHz(20~20kHz,A-weight,Noload)
SNR 121dB(20~20kHz,A-weight)
OutputLevel +12/+8/+4/0 dBu
ChannelIsolation -135dB
Dynamic Range 122dB@1kHz(20~20kHz,A-weight)
NoiseLevel -120dBu
FreqResponse +0.005/-0.259dB (20~20kHz)
THD+N 0.00025%@1kHz(20~20kHz,A-weight,Noload)
SNR 121dB(20~20kHz,A-weight)
OutputLevel +12/+8/+4/0 dBu
Dynamic Range 122dB@1kHz(20~20kHz,A-weight)
NoiseLevel -118dBu
Crosstalk -120dB
SNR 121dB(20~20kHz,A-weight)
OutputLevel +12dBu(High Gain) -5.6dBu(Low Gain)
ChannelIsolation -135dB
Dynamic Range 122dB@1kHz(20~20kHz,A-weight)
NoiseLevel -120dBu
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject
to the following twoconditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This
equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
