8
For Irish tension wheels:
For Scotch tension wheels:
Take the flyer with bobbin and put
it in place; the axle into the bearing
in the post and the orifice onto the
brass bearing at the front.
Insert the axle of the flyer, with a
bobbin on it, into the central hole
of the pulley. In this hole is a pin
that fits the slot at the end of the
axle. The system is magnetic, so
when you turn the flyer it will snap
in at the moment the slot and the
pin are aligned.
Brake system Irish tension:
Brake system Scotch tension:
The brake band can be completely
released when you start with an
empty bobbin.
Place the brake cord into the
groove in the bobbin end, lead it
at both sides along the little hooks
and turn the tensioning knob at
the front just enough to straighten
and stretch it a tiny bit. Make sure
that you have the same number of
windings on the knob at both
sides.
