About the product
The Alarm Siren Tree with strobe light serves as an external
warning device, for example, as part of the burglar alarm.
When triggered, the device gives out an acoustic and optical
alarm. The integrated tamper switch provides additional
protection.
Features
• Acoustic alarm
• Optical alarm
• Tamper detection
Installation
Install the product in your desired installation place and make
sure that it’s mounted over the cable outlet. Make sure that you
choose an installation place where the product is protected
against extreme weather conditions.
Connect power and Tree communication by using the provided
moisture-resistant pigtail connectors. Once powered, pair the
product with your Miniserver using Loxone Config. To finish the
installation, place the top cover as seen in the picture on the
base unit and fix in place with the two screws on the bottom.
For additional information, declaration of confirmity,
visit www.loxone.com/help/alarm-siren-tree
2nd)
fix cover with
screws
1st)
clasp into
housing and
close cover
This folder is a part of the product! Insert wire and
press to make
connection
Connection
Wire cross-section 0.4 … 0.8mm² / AWG26 … 19
Stripping length must not be stripped
Temperature resistance -40 ... 140 °C / -40 ... 284°F
