LOXONE NFC Code Touch Air User manual

Part No.: 100299 (white)
Part No.: 100305 (anthracite)
Need Help?
loxone.com
No Gimmicks.
Real Smart Homes.
NFC Code
Touch Air
Technical Specifications
Access Possibilities NFC (Only when SELV/PELV
powered), Key Code
Power Supply 9...28VDC SELV/PELV or
CR2450 Lithium Battery
Power Consumption SELV/PELV
Powered
typ. 0.08W, max. 0.7W
(while reading NFC)
Power Consumption Battery
Powered
typ. 0.01W, max. 0.06W
Battery Lifetime Approx. 1 year
Radio Frequency 868MHz (SRD Band Europe),
915MHz (ISM Band Region 2)
max. Power 3.16mW
Safety Rating IP44
Ambient Temperature -20...55°C / -4...131°F
Humidity 95% r.H. (non condensing)
Maintenance & Cleaning This device is free of main-
tenance and may only be
cleaned with a dry cloth.
Loxone Electronics GmbH
Smart Home 1
4154 Kollerschlag
Austria
loxone.com/support
Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired operation
Connection
Wire Diameter 0.32...0.08mm² / AWG22...
AWG28
Exposed Wire Length 3.5mm / 0.14“
Push-In-Technology To make connection, insert
wire; to remove the wire twist
and pull at the same time.

About the product
Get access to your Smart Home with encrypted or unencrypted
NFC tags, via your NFC enabled smartphone or through your
own unique key code.
Features
• Authentication via encrypted and unencrypted NFC Tags or
NFC enabled smartphones or key code
• Supports permanent, disposable or time-limited key codes
• Universal button
• Alarm-authentication
Installation
Install the mounting frame of the NFC Code Touch on the
desired installation place. Power up the device and pair it with
your Miniserver in Loxone Config. Alternatively you could power
up the device with the provided battery, but note that due to
higher need of power the authentication with NFC and the
background light will not work. To finish the installation attach
the NFC Code Touch as shown on the mounting frame.
For additional information, declaration of confirmity,
visit www.loxone.com/help/nfc_code_touch
Important Information
• Due to the higher power demand, the NFC-Reader and
background lighting will only work when the device is
externally powered with SELV/PELV
• For security reasons, we strongly suggest you only use
encrypted NFC tags for access control from Loxone.
• If the NFC Code Touch is being powered by battery, please
note the keypad must be woken up with the check mark
prior to entering the key code. 24V
GND
Universal
Button Attach hereNFC Sensor