LOXONE Touch Surface Air User manual

Part No.: 100285
Need Help?
loxone.com
No Gimmicks.
Real Smart Homes.
Touch
Surface Air
Technical Specifications
Surface Material Stone, Wood, Ceramic or
Glass – Please note that this
product will not work with
conductive materials.
Surface Thickness max. 30mm / 1 3/16”
Power Supply 9...28VDC PELV or Battery
Pack (Not included)
Power Consumption PELV
Powered
typ. 67mW, max. 133mW
(when LEDs on)
Power Consumption Battery
Powered
typ. 0.25mW, max. 100mW
(when LEDs on)
Battery Lifetime Approx. 2 years
Radio Frequency 868MHz (SRD Band Europe),
915MHz (ISM Band Region 2)
max. Power 3.16mW
Ambient Temperature (PELV)-20...70°C / -4...158°F
Humidity 95% r.H. (non condensing)
Safety Rating IP20
Loxone Electronics GmbH
Smart Home 1
4154 Kollerschlag
Austria
loxone.com/support
Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired operation
Connection
Wire Diameter 0.14...1mm2 / AWG18...AWG25
Exposed Wire Length 7mm / 9/32”
Push-In-Technology To make a connection, insert
the wire; to remove the wire
twist and pull at the same
time.
Ambient Temperature (Battery powered)-20...54°C / -4...129°F
Dimensions304x115x18 mm / 12x4.53x0.71" (LxWxH)

About the product
Installed underneath your non-conducting surface (Note the
max. surface thickness of 30mm), the Loxone Touch Surface
gives you the possibility to control your smart home using the
Loxone switch standard.
To prevent accidental use, there is an activation button.
Upon touching this button, the five touch points of the switch
are activated for 5 seconds, and the remaining time will be
displayed through the activation indicator. If the activation
function is not needed, the activation button can be
reconfigured as necessary in Loxone Config.
Features
• Loxone Switch Standard
• Accidental operation protection
• LED activation indicator
Installation
Installation without activation indicators
If you would prefer not to install the light pipes or mark the
surface at all you can use the provided decal to show the touch
points.
Mount the Touch Surface to the underside of the surface.
Once powered up, learn-in and configure the Touch Surface
using Loxone Config.
For additional information, declaration of confirmity,
visit www.loxone.com/help/touch-surface-air
Installation with activation indicators
Prepare the surface on which the Touch Surface is to be
installed by drilling 5 holes for the LED indicator lights and
marking the touch points (We strongly recommend that the
holes are drilled by a professional to avoid damage to the
surface).
The activation indicator lights need to be installed on the
Touch Surface prior to mounting it.
Mount the Touch Surface to the underside of the surface.
To seal the holes for the activation indicator lights, use a
transparent epoxy resin. It is important to ensure that no dirt or
grit is present in the holes or on the underside of the mounting
surface prior to using the resin. When applying the resin ensure
that no air bubbles are created.
Once powered up, learn-in and configure the Touch Surface
using Loxone Config.
Activation button
Download free
DXF-Template
www.loxone.com/
touch-surface
Status-LED
Mounting Hole
Power Supply
Learn Button Mounting Holes
Touch points
Decal for touch
surfaces
Support film
Light pipes
304
12
3
45
6
115