3
> ERGOLIFT HEAD DESCRIPTION
> CARE CHAMBERS DESCRIPTION
FIG. 1 FIG. 2FIG. 3
Flap TML 20
Care
chamber
TML20
removable flap
Only the TML20 and TML10
care chambers can be
connected to the Ergolift head.
They can be connected and
disconnected by a simple
push-pull action.
Flap TML 10
Care
chamber
TML10
removable flap
SELECTION BUTTON FOR CARE TYPE
POWER INCREASE BUTTON
POWER DECREASE BUTTON
ON/OFF BUTTON
HOSE CONNECTION
CARE CHAMBERS CONNECTION
They can be connected and
disconnected by a simple
push-pull action.
> CLEANING THE ERGOLIFT HEAD
AND CARE CHAMBERS
CLEANING THE ERGOLIFT HEAD AND CARE CHAMBERS
For reasons of hygiene, the care heads should be cleaned after each use, using antiseptic
wipes impregnated with a bactericidal and fungicidal solution.
Special attention must be given to the cleanliness of the parts that are in contact with the client.
Before each use, clean the flap and care chamber.
1. Disconnect the Ergolift head care chamber. (fig. 1)
2. Remove the flaps. (fig. 2)
3. Meticulously clean the care chamber and flap for at least
1 minute with the aboved mentionned wipes. (fig. 3)
A personal Endermolift Kit for the client is available for sale. It can be used for
approximately 20 treatment sessions.
DISINFECTING THE CARE CHAMBERS
The Ergolift head are in direct contact with client’s skin. Under certain specific
applications, it needs to be disinfected after each use:
1. Follow the cleaning procedure described above.
2. Soak the flap and care chamber in an OPA disinfectant for 12 minutes at 20° C, as
recommended on the disinfectant packaging.
3. Carefully rinse the flap and the care chamber with sterile or drinking water for at least 1
minute using a large volume of water (approximately 8 liters). Repeat twice for a total of 3 rinses.
4. Dry the care chamber and flap.
5. Clean the storage drawer with antiseptic wipes, then place the care chamber and flap in it.
The use of aggressive products, such as acetone, trichloroethylene, or alcohol at 90°, and abrasive sponges,
ultrasound or UV lamps is strictly prohibited. All cleaned and/or disinfected heads should be placed in the storage
drawer to avoid any confusion. Use a disinfectant whose active ingredient is ortho-phthalaldehyde (OPA). Before using
the disinfectant, read and follow the recommendations, contraindications, and warnings associated with this product.
Refer to the instructions for using this solution.
≥ATTENTION
MAINTENANCE
For reasons of hygiene, the care heads should be cleaned after each use, using antiseptic
wipes with a bactericidal and fungicidal solution.
Special attention must be given to the cleanliness of the parts that are in contact with
the client.
