2
CONGRATULATIONS, on purchasing a quality Lucci ceiling fan. Lucci, a 100% Australian owned
company has been developing ceiling fans since 1980, and over those years has introduced innovations
to suit Australia’s unique environment and customer needs.
The information contained in the following pages has been prepared to ensure trouble-free operation of
your ceiling fan .
1. To ensure the successful installation be sure to read the instructions and study the diagrams
thoroughly.
2. For your safety, all electrical connection and disconnection must be performed by a Licensed
Electrician.
3. All electrical work should only be undertaken after disconnection of the power by removing fuses or
turning off the circuit breaker to ensure all pole isolation of the electrical supply. If you are in any
doubt the services of a qualified electrician should be sought to ensure that all work is carried out in
accordance with the local regulations, current good practice and other national and local electrical
codes.
4. Make sure that your installation location will not allow the rotating fan blades to come into contact
with any object and that there is a minimum clearance of 30cm from the blade tip to the wall or
nearest object. Please note that the bigger this clearance is the better the airflow from your fan will
be. Ensure the blades are mounted at a minimum height of 2.1 meters from the floor when the fan is
installed.
5. The fixing point for the fan must be able to support a weight of at least 30kg. If you are mounting the
fan to a ceiling junction box, the box and it’s fixing must be able to support the moving weight of the
fan and must not twist or work loose.
6. The fan must be earthed.
7. Do not connect the fan motor to a dimmer switch. This may give an unsatisfactory performance
(motor hum) and cause damage to the motor. Only use the supplied wall controller.
8. It is not recommended that ceiling fans and gas appliances be operated in the same room at the
same time.
9. The fan must be turned off and stopped completely before reversing the fan direction. This will
prevent any damage to the motor of the unit or controllers.
10. Do not insert anything into the fan blades while the fan is operating, as this may cause person injury,
damage the blades, and upset the balance of the unit causing the unit to wobble.
11. After the fan is completely installed make sure that all screws are secured and tightened to prevent
any problems.
12. Because of the fan’s natural movement, some screws may loosen. Check the mounts, brackets and
blades twice a year to make sure they are all secured. If they are loose, tighten with a screwdriver.
Note: The important safeguards and instructions given in this manual are not meant to cover all possible
conditions and situations that may occur. It must be understood that common sense, caution and care
are factors, which cannot be built into any product. The persons caring for and using the unit must
supply these factors.
For installation advice, or in the unlikely event of damaged or missing parts please consult a licensed
electrician.
