Welcome to Lumapower
Please take a moment to register your product on our Web site at
http://www.Lumapower.com. It enables us to keep you posted on our latest advancements,
and helps us to better understand our customers and build products that meet their needs
and Expectations. This product has been designed and manufactured to the highest quality
standards. However, if something does go wrong with this product, Lumapower and its
national distributors warrant free of charge labour and replacement parts in any country
served by an official distributor.
Unpacking: Check the product carefully. If it has been damaged in transit, report the
damage immediately by calling your dealer and/or the shipping company that delivered it.
Read Instructions. All the safety and operating instructions should be read before the
product is operated.
Follow Instructions. All operating and use instructions should be followed.
Replacement Parts. When replacement parts are required, be sure the replacement parts
have the same characteristics as the original part. Unauthorized substitutions may cause
damage to the unit.
Introduction
Lumapower MENTOR SX supports input voltage from 3.6V to 12V. It is powered by 3 x C-cell
(Alkaline, NiMH), (1 or 2) x C size (Rechargeable Li-ion) (with 6 or 6, 7. removed). MENTOR
SK is fitted with pure white LED module driven by current regulation circuitry to achieve a
consistent level of light output for the useable life of the batteries. Never use more than 2
x rechargeable Li-ion batteries, it may damage your flashlight.
MENTOR SX features a forward clicky switch and SideKick digital output control cirit with
memory functions.
Half-press the tail switch to power on MENTOR MT-E momentary, full press to lock it for
constant on. Another full press to release the lock (power off)
SideKick-4 Digital output control
Mode A and Mode B :
Press and hold the SideKick switch for 2 seconds to switch from Mode A and Mode B.
Mode A : Quick press and release the SideKick switch to cycle the output from Ultra, High,
Medium, Low and Lowest.
Mode B: Quick press and release the SideKick switch to cycle the output from Tactical
Strobe, SOS and Light-house
Memory: The output level and status will be stored when you power off the light and
restore at next power on.
Battery Installation
Unscrew the tail switch housing and insert new batteries with positive ends towards LED
assembly. Replace tail switch and hand tighten. Depress tailcap pushbutton switch to test.
Note: It would not light if battery is inserted in wrong direction.
CAUTION: MENTOR SX tool-light are high-output lighting devices. Due to possible
eye injury, DO NOT look directly into the reflector when the light is switched on.
Safety is your responsibility, too.
External surface temperature will rise during prolonged operation; this is a normal operating
phenomenon.
Battery Replacement
If there is significant decrease in brightness of light output you should replace the battery.
Unscrew the LED-engine and remove the old battery. Insert a new battery as mentioned in
Battery Installation Guide
WARNING: Do not place loose batteries in a pocket, purse or other container
containing metal objects or store with hazardous or combustible materials. Store in cool, dry,
ventilated area. Follow applicable laws and regulations for disposal.
Maintenance
Clean and lubricate threads with a clean cloth and apply thin coat of silicon-based lubricant to
rubber O-rings. Note: Do not use petroleum-based lubrication on O-rings. After prolonged
exposure to moisture, the bezel and batteries should be removed, inspected, and dried if
necessary.
WARNING: Lumapower reflector is made with high precision process. Do not touch
or clean the reflecting surface using any cloth which may cause damage to the surface
material affecting the illuminating performance.
