Lumens DC260 User manual

English - 0
DC260 Visual Presenter
Quick Start Guide

English - 1
1. Package Content
DC260 Quick Start Guide User Manual
Remote control CD Base Installation Guide

Software Bag VGA Cable USB Cable
C-Video Cable Remote Control
Holder
Microscope Adapter
Power Cord Padded Carry Bag
(Optional)
RS232 Adapter
(Optional)
Appearance may vary with
country/region.

English - 2
2. Product Overview
(Bottom)
6. DIP switch
3. Control panel
5. Lens
4. LED indicator
1. Lamp
2. Remote sensor

English - 3
2.1 Relative Position of the Presenter and DC260
2.2 Recommended Distance
About 470mm distance between camera and the desktop is
recommended.
Presenter
DC260
Document

English - 4
2.3 Incorrect Use

English - 5
3. System Diagram
PC
PC
Microphone
Projector
Monitor
Television
LCD TV
Speaker
SD Card

English - 6
4. Mounting the DC260 at Desktop
1. Please set up the DIP Switch settings first. Refer to chapter 5 "DIP
Switch Settings" in the DC260 user manual.
2. Please refer to the Base Installation Guide for installation instructions for
all parts.
5. Connecting Devices
5.1 Step 1: Plugging in the Power Outlet
<Note> Appearance of power cord may vary with countries/regions.
5.2 Step 2: Connecting with components
5.2.1 Connecting to a Projector or Monitor
zConnect the VGA Out on the DC260 to the VGA IN on the projector or the
monitor using the VGA cable.
5.2.2 Connecting to a TV
1.Use C-Video cable to connect TV.
AC Outlet

English - 7
2.Adjust DIP Switch Setting

NTSC：America, Taiwan, Panama, Philippine, Canada, Chile, Japan, and Mexico

PAL：Country/region not listed above:
<Note> VGA output is not supported once C-Video output enabled.
<Note> You are unable to use the [Menu] / [Rotate] / [Half Page] /
[Source] / [Record] / [Capture] / [Delete] / [PBP] / [Slide Show]
functions in C-Video mode.
3.Restart the DC260
DIP Switch setting will not be available until restarting the DC260.
5.2.3 Connecting to a LCD TV/ PDP
zUsing the HDMI cable to connect a LCD TV/ PDP

English - 8
Speaker
電腦
5.2.4 Connecting to a Computer
zConnecting to a computer through VGA in
zConnecting to a computer through USB
Connect to USB port then install the supplied queue program. Please refer to
the DC260 user manual 4.6 Installing driver and application queue.
zConnecting to a computer through RS232 (RS232 Adapter is optional)
5.2.5 Connecting to Speaker

English - 9
Microphone
5.2.6 Connecting to Microphone