Lumens DC265 User manual

DC265 Visual Presenter
Quick Start Guide
English - 0

1. Package Content
DC265 Quick Start Guide User Manual
(For download of other
language versions, please
visit Lumens website)
Base Installation Guide &
Download Card Remote control Remote Control Holder

Extender Adapter VGA Cable USB Cable
C-Video Cable Power Cord Microscope Adapter
Appearance may vary with
country/region.
Accessory Pouch Backlight (Optional) Padded Carry Bag
(Optional)
English - 1

2. System Diagram
PC Monitor Projector Monitor
PC
Speaker
SD Card
PC Television
LCD TV
English - 2

3. Mounting the DC265 at Desktop
1. Please set up the DIP Switch settings first. Refer to chapter 5 “DIPSwitch
Settings” in the DC265 user manual.
2. Please refer to the Base Installation Guide for installation instructions for
all parts.
4. Connecting Devices
4.1 Step 1: Plugging in the Power Outlet AC Outlet
English - 3
<Note> Appearance of power cord may vary with countries/regions.
4.2 Step 2: Connecting with components
4.2.1 Connecting to a Projector
zConnect the VGA OUT on the DC265 to the VGA IN on the projector using
the VGA cable.
4.2.2 Connecting to a Monitor
zConnect the VGA PASSTHROUGH on the DC265 to the VGA IN on the
monitor using the VGA cable.
<Note> The VGA PASSTHROUGH connector only outputs VGA IN
signals.

4.2.3 Connecting to a TV
1.Using EXTENDER and C-Video cable to connect EXTENDER of DC265 to
a C-Video of TV.
2.Adjust DIP Switch Setting

NTSC：America, Taiwan, Panama, Philippine, Canada, Chile, Japan, and Mexico.

PAL：Country/region not listed above:
<Note> OSD is not available in C-Video. Functions such as [Menu] /
[Rotate] / [PAN] / [Source] / [Record] / [Capture] / [Delete] / [PBP] /
[Slide Show] are not available on control panel and the remote control.
<Note> VGA output is not supported once C-Video output is enabled.
3.DIP Switch setting will not be available until restarting the DC265.
4.2.4 Connecting to a LCD TV/ PDP
zUsing the HDMI cable to connect a LCD TV/ PDP
English - 4

4.2.5 Connecting to a Computer
zConnecting to a computer through VGA IN
zConnecting to a computer through USB
Connect to USB port then install the supplied queueTM program. Please
refer to the DC265 user manual
English - 5
電腦
Speaker
zUsing the EXTENDER and RS-232 cable to connect EXTENDER of
DC265 to a RS-232 of computer.
4.2.6 Connecting to Speaker

5. Start Using the DC265
5.1 Turn on the DC265
Control Panel Remote Control
zWhen using the remote control, aim at the receptor on the DC265,
and press the power button.
zOnce DC265 is turned on, the LED on the control panel will flash a
few times and stay lit. Please contact your distributor if the LED is not
on.
<Note> Once the password page is shown, please key in the
password. If you forget it, please contact your distributor or the
service center.
*For detailed menu function introduction and operation instructions, please refer
to the user manual.
English - 6