LUMIEN CORE User manual

Lumien Lighting | Website: www.lumienlighting.com | E-mail: [e-mail]
INSTRUCTION MANUAL
(Integrated LED)
WARNING –To reduce the risk of FIRE OR INJURY TO PERSON:
• Turn off/unplug the fixture and allow to cool before replacing lamp.
• Lamp gets HOT quickly. Only touch the switch/plug when turning on.
• Do not touch the hot lens, guard, or enclosure.
• Keep lamp away from materials that could burn.
• Do not touch the lamp at any time. Use a soft cloth. The oils from skin could damage lamp.
• Do not operate the fixture with a missing or damaged shield.
WARNING –Risk of Electric Shock:
• Install all luminaires at least 10 feet (3.05 m) from a pool, spa, fountain, etc.
• A fixture shall not use tungsten halogen lamps unless the luminaire is marked for such lamps.
IMPORTANT:
DO NOT EXCEED 15 VOLTS IN THIS FIXTURE!
This fixture functions best when the incoming voltage is between 10–15 volts. Voltages outside of this range could damage the
fixture, shorten the life, and cause unsatisfactory performance. The use of improper voltage voids the product warranty.
MODELS
Brass
CORE
W4B4
RGBWW PRO
W9B4
Wattage
CORE: 2.5W
PRO: 2.5W
Voltage Range
10-15V
Lumen Output
CORE: 110 Lumens
PRO: XXX Lumens
Color Temp
3000K, 2700KRGBWW
CRI
80+
Lifespan
50,000 Hrs.
Finishes
Antique
Housing Material
Brass
Wet Rated?
Yes
Light Source
Modular LED

Lumien Lighting | Website: www.lumienlighting.com | E-mail: order[email protected]om
TRANSFORMERS
• Only use a UL1838 transformer for safety reasons and to ensure full lifespan of the fixture.
• When using ONE transformer, it is very important to center the transformer on the wattage load to minimize cable runs.
• When using MULTIPLE transformers, it is very important to position the transformers as close to the fixtures as possible to
minimize cable runs.
LOW VOLTAGE CABLE SHALL:
• Be protected by routing near the luminaire, or next to a building structure such as a house or deck.
• Not be buried more than 6 inches.
It is not recommended to use Quick Clip style connectors because they are not waterproof and can rot creating resistance
and shorts. Only use outdoor rated waterproof wire connectors. Install in accordance with all local codes and ordinances.
LED LIFE
• For maximum light output, fixtures should be connected to 10-15 volts taps.
• Voltage can be regulated by adjusting load/run.
• To determine voltage, use a digital voltmeter.
IN-WALL INSTALLATION:
•Determine the desired location for each fixture before construction of wall is started.
•Insert mounting plate A in between layers of hardscape material.
•Route the fixture wire through the wall to the main low voltage wire run. A notch can be cut into the hardscape material to
aide in wire management if desired.
•If needed, use screws or adhesive to secure the fixture.
•Connect fixture wires to main low voltage wire run using waterproof wire nuts.
•To install light module, insert module (B) into housing (A) and use screws (C) to secure the module. Remove screws (C) to
replace modules if needed.
•For the PRO Fixture , follow the instruction on our LumienPRO’s remote control.

Lumien Lighting | Website: www.lumienlighting.com | E-mail: order[email protected]om
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship from date of purchase
for a period of ten (10) years for Aluminum and Lifetime for Brass. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s
only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion,
provided that the product has not been damaged through misuse, abuse, accident, modification, alteration, neglect, or
mishandling.
WHAT IS COVERED
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in
accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product because of
an accident, misuse, abuse, negligence, alteration, faulty installation, or any other failure not relating to faulty material or
workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as
this is considered normal wear and tear. The manufacturer does not warrant and especially disclaims any warranty, whether
expressed or implied, of fitness for a purpose, other than the warranty contained herein. The manufacturer specifically
disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not limited to
any labor/expense costs involved in the replacement or repair of said product.