Lund Industries SSTB-FLEX User manual

SSTB-FLEX SecureStor 31 x 40
Ford Flex Vault Mounting Instructions
CAUTION: Always check before drilling or screwing to be certain not to hit anything
(fuel tank, lines, wiring, etc) beneath the carpet, the transmission hump or under the
vehicle.
Rear Mounting: Lift rear seats upright. Remove rear threshold plastic trim. Screw small
bracket into floor under plastic threshold using luggage clip bolts
as shown in Figure1. Notch out plastic trim as shown in Figure 2. Replace plastic trim and
stow seats to level the floor.
Attach flat brackets to the bottom of the supplied rail using 3/8” hardware and leave loose for
rail adjustment. Attach flat bracket to the short rear mounting bracket w/ 3/8” hardware.
(Figure 3)
Front Mounting: Remove seat belt attachment near floor. Install “L” bracket under the seat
belt bracket and tighten. (Figure 4)
Install the vault in the vehicle, align rail and seat belt bracket with pems in side of vault.
Tighten all bracket and rail hardware when properly positioned. Attach SecureStor vault with
3/8 hardware and tighten securely.
Be certain spare tire jack is accessible before installing vault. For access to spare tire,
wing bolts can be substituted for 3/8” bolts. Remove wing bolts and slide vault forward.
01/10

Figure 1
Figure 4
Notch plastic
trim here
Factory tie-down
bolts
Figure 2
Figure 3
“L” bracket
under factory
seat belt bolt
Wing bolts
for spare tire
removal
Wing bolts
for spare tire
removal