LuxenHome WHPL1274 User manual

WHPL1274
Two - er Galvanized Raised Garden Bed
PREPARATION
SAFETY INFORMATION
Before assembling product, make sure all parts are present. Compare parts with
package contents list and hardware contents below. If any part is missing or damaged,
do not attempt to assemble the product.
Tighten all the screws before using.
This planter is intended for outdoor use only. The floor may be wet when watering
the plant.
Not for use by children. Keep children and pets away from the planter.
It’s suggested to wear gloves when assembling product.
Tools required for assembly (included):Allen key

A
B
C
Part QuantityDescription
1
2
1
I J
HARDWARE CONTENTS
PACKAGE CONTENTS
back panel
front panel
right short panel
righ long panel
left short panel
left long panel
tall frame
short frame
K
A
B
B
C
D
E
F
G
H
G
H
H
H
D
E
F
G
H
1
1
1
2
4
Part QuantityDescription
36PCS
Bolt Nut Allen key
36PCS 1PC

ASSEMBLY INSTRUCTION
1
2
Hardware Used:
Bolt
x4I
Nut
J x4
Hardware Used:
Bolt
x16I
Nut
J x16
E
F
C
D
I
J
J
I
Ix8
Ix8 EFCD
H
H
H
G
G Jx8 Jx8
Left - side Right - side
Right - sideLeft - side
Align the holes on the left long panel (F) with the botton two holes on the left short panel (E).
Attach the panels with bolts (I) and nuts (J).
Do the same way to the right long panel (D) and right short panel (C).
Align the holes on the tall frame (G) with the holes of left short panel (E). Attach the tall frame
and short panel with bolts (I) and nuts (J).
Align the holes on the short frame(H) with the top two holes of left short panel (E) Attach the
short frame and short panel with bolts (I) and nuts (J).
Align the holes on another short frame (H) with the holes of left long panel (F). Attach the short
frame and left long panel with bolts (I) and nuts (J).
Do the same way to the tall frame (G) right short panel (C) right long panel (D) and short frame (H)

Hardware Used:
Bolt
x8I
Nut
J x8
Hardware Used:
Bolt
x8I
Nut
J x8
B
B
Ix4
Ix4
Jx8
3
Jx8
Ix8
A
4 3
Attach back panel (A) to the left part and the right part with bolts (I) and nuts (J).
Attach front panels (B) to with bolts (I) and nuts (J).