LWA SOS User manual

WORK INSTRUCTION
Personal Emergency Alarm - LWA SOS
INSTRUCTIONS
The LWA SOS (pictured below) has (3) three LED indicator’s with buttons below them.
The left hand LED is Amber and indicates GSM (Mobile phone network) connectivity.
The button (Call button # 2) is used as a speed dial function for quick and easy 2-way
communications with :
_ ___________________ ______________
Simply push any button on the top briefly to hang up the call when finished
The centre LED is Red and indicates power & activity
The centre button (SOS) is used to activate, silent Red Alert alarm
(this produces SMS containing, last known GPS location, speed, battery life, time & date +
generates a silent telephone call, through to the
Incident Response Centre (IRC) , enabling experienced staff to monitor your location and
act accordingly to your emergency. .
Note: The user cannot finalise this emergency RED alert call, the operator will stay
online until they Know the client is safe and well...
The right hand LED is Blue and indicates GPS signal is currently being received
The button (Call button # 1) is used as a speed dial function for quick and easy 2-way
communications with :
_ ____________________________________________ _
Simply push any button on the top briefly to hang up the call when finished
Right hand side of the unit is the ON / OFF and Status button.
ON = Simply press and hold the button until all 3 lights start to flash
Release the button (unit will now configure itself)
In approximately 45 seconds the lights will start to flash in a regular sequence,
indicating status as described above.
Unit is now ready for use
Off = Simply press and hold the button until all 3 lights start to flash, release the
button (unit will now turn OFF)
Audio speaker is located at the top right hand side
Microphone is located at the top left hand side
Just below microphone is the USB port for the charger.

WORK INSTRUCTION
Personal Emergency Alarm - LWA SOS
Care of Unit
The unit should either be on your person or on charge
Use of Charger:. When not in use, the unit should be placed on charge.
When unit is on charge ALL functions are DISABLED
Use the charging tools provided (GPO/USB charger head + USB to mini USB lead.
1. Plug mini USB into the side of the unit as described above
2. Plug the USB lead into the GPO plug provided
3. Plug the plug head into a suitable general power outlet
4. Ensure outlet is turned ON and active
(All LED’s should flash for short period, then only RED & when fully charged all
LED will go off –approx 4 hours from flat)
The above use, will ensure the unit is always at maximum charge and ready for use. .
When the unit is taken off the charger it is fully operational and will acquire its initial GPS
position within a couple of minutes.
Handling:
Whilst the unit is designed to withstand normal wear and tear, it is not waterproof.
It is as robust as your mobile phone. If it is immersed water for any period of time it will not
function again.
SIM card:
The SIM card is not suitable for any other device and is not to be removed from the unit
under any circumstances.
Actual Size