Magbot SE-10 User manual

MAGBOT SE-10 3D Printer User Manual
INDEX
Title Page
1. Machine Information ---------------------------------------------------------------------------------- 1
2. Machine Installation ---------------------------------------------------------------------------------- 2-5
2.1 Open Package ------------------------------------------------------------------------------------------ 2
2.2 Check Machine, accessories and tools ----------------------------------------------------------- 2
2.3 Install Filament Holder -------------------------------------------------------------------------------- 3
2.4 Nozzle Preheat ------------------------------------------------------------------------------------------ 3
2.5 Insert Filament ------------------------------------------------------------------------------------------- 4
2.6 Level Platform -------------------------------------------------------------------------------------------- 5
3. Software Use ---------------------------------------------------------------------------------------------- 6-11
3.1 Installing Software --------------------------------------------------------------------------------------- 6-10
3.2 Software Settings ---------------------------------------------------------------------------------------- 9-11
3.3 Software Operation -------------------------------------------------------------------------------------- 11
4. Start Printing ----------------------------------------------------------------------------------------------- 12
4.1 How to Start Printing ------------------------------------------------------------------------------------- 12
5. Operation Panel -------------------------------------------------------------------------------------------- 12-13
5.1 Printing Interface Introduction -------------------------------------------------------------------------- 12
5.2 Main Interface, Interface --------------------------------------------------------------------------------- 13
5.3 Move, Zero Interface -------------------------------------------------------------------------------------- 13
5.4 Print, Extruder Interface ---------------------------------------------------------------------------------- 13
5.5 Fan, Setting Interface ------------------------------------------------------------------------------------- 13

Page | 1

Page | 2
Package List
1 x 0.25KG Filament
1 x SD Card
1 x Card Reader
1 x Cutter
1 x Multi Purpose Tool
1 x Masking Tape
1 set of heat block, heat break and nozzle.

Page | 3
*Note: Interface and Language might be slightly different as it depends on which country that
this printer is purchased.

Page | 4

Page | 5
*Note: Interface and Language might be slightly different as it depends on which country that
this printer is purchased.

Page | 6

Page | 7

Page | 8

Page | 9