Majacraft Pioneer Quick start guide

1
majacraft
majacraft
all you need to spin your dreams...
Your new
Pioneer
spinning wheel

2
majacraft
Joiner screws - 25mm (1”)
To aach the rubber joiners on the
conrods to the pedals
Crank screws - 38mm (1 1/2”)
To aach the crank assembly to the
drive wheel
Base bolt - JCB 40mm (1 1/4”)
To hold the base and stem assembly
together
Fastener Details
Welcome to the Majacraft family
Congratulaons on purchasing a new Majacra Pioneer.
We are very proud of this wheel and hope that it allows you to express your creavity in new and
excing ways. Take me to read through the instrucons before assembly, it really is worth it.
One of our goals is to make our wheels as easy and simple to use as possible, so they become
almost invisible as you express your creavity through bre.
If you were not already aware, we have designed all of our cra tools and accessories to be
compable with each other. If you have an interest in a specic technique, we are likely to have
specialist accessories that will t straight on to this wheel or tools to make creang easy. Talk to
your dealer, visit our web site or email us directly and we will do what we can to help.
Thank you for choosing Majacra, it is your belief in us that drive our innovaon and creavity in
building capvang tools for you.
From the team at Majacra, good spinning!

3
majacraft
Assembling a Majacraft Pioneer
1. Prepare the components
These instrucons demonstrate how to assemble your Majacra Pioneer spinning wheel.
2. Attach stem to base assembly
We recommend that you nd a clear work area where you
can lay out all the components for working on them.
The following tools are provided by Majacra
- 5mm allen key
- 4mm allen key
- 2mm allen key
You will also need the following tools:
- Posidrive (Philips) screwdriver
Please unpack with care and retain the packaging. In the box will be:
Required:
3 - M6 40mm JCB (1 1/2”) bolts (in the hardware bag)
4mm allen wrench (in the hardware bag)
Stem assembly
Base assembly
1 Base/Pedal assembly
1 Stem/Brace assembly
1 Head assembly
1 Drive wheel with drive axle
3 Plasc Bobbins
1 Flyer
1 Crank and Conrod assembly
1 Hardware Bag (screws, etc) spare screws are included
2a 2b

4
majacraft
You will require the three 40mm JCB bolts. The 4mm allen key is necessary. Posion the base
assembly on it’s edge and then push the JCB bolts through from underneath. Take care that the
pedals do not swing free and become damaged.
Align the JCB bolts with the threaded holes in the
stem and the brace. Use the 4mm allen key to screw
the JCB bolts into place.
Do not ghten the bolts fully yet. Repeat this with the remaining
two JCB bolts. When they all in place then ghten bolts securing
the stem onto the base assembly.
Required:
5mm allen key (in the hardware bag)
Base/Stem assembly
Drive Wheel
3. Attach drive wheel to stem
2c
2d
2e
3a

5
majacraft
The drive wheel has the axle already in place. Align
the end of the axle with the threaded insert on the
stem.
Required:
Head Assembly
Base/Stem Assembly
Hex Lock Bolt
4. Head assembly on to stem
3b
3c
3d
3e
4a
When located correctly, use the 5mm allen key to
screw the axle bolt into the stem. Tighten it rmly
The drive wheel is now aached
to the base/stem assembly.