Major Manufacturing DL1200 Trilogy User manual

Directions for HIT-32AL3 Drill Guide
For Alarm Lock DL1200 Trilogy
1825 Via Burton
Anaheim, CA 92806
714-772-5202 / fax [phone]
www.majormfg.com
[email protected]
Aluminum door
frame with
dead latch in-
stalled.
Remove faceplate
and all inside and
outside hardware
Alignment for the
drill guide is
achieved with the
use of our HIT-22
mortise cylinder
alignment tool.
This devise will
mount in the
mortise cylinder
hole.
Hit-22 installed
and held in place
with the mortise
cylinder set
screw. Note:
Alignment pin
shown in guide,
this will first go
through the HIT-
32 drill guide
then into the
HIT-22.
Fig 1
Fig 4Fig 3
Fig 2

Using a combina-
tion square,
square the drill
guide to door. The
backset will auto-
matically be
centered with the
HIT-22. Do not let
the guide slip in
this step.
NOTE: MOUNT
ON DOOR WITH
ENGRAVING IN
UPRIGHT
POSITION.
Use the drill screws
that were supplied
with the guide and
attach one using an
electric drill. NOTE: A
drill with a clutch drive
is a big help, you do
not want to snap a
screw in the door. The
screw mounting holes
are located between
the drill bushings top
and bottom. Screw
only to one side of the
door.
Remove the two drill
screws holding the
guide to the door.
Drill four 7/32”
holes on both
sides of the door
using the drill
bushings located
at the corners.
Remove the
HIT-22 locating
tool. A handle is
supplied that
makes the job
easier.
The door is now ready
to install the Alarm
Lock DL1200. Note:
the screw holes used
to mount the guide will
be covered by the lock
and will not be visible
once the installation is
completed. Install lock
per manufacturers
directions.
Fig 5 Fig 6
Fig 9
Fig 7 Fig 8
Fig 10
ENGRAVING

Completed installation.