Marmitek IR 100 USB User manual

IR 100 USB
20618/ 20140324 • IR 100 USB™
ALL RIGHTS RESERVED MARMITEK ©
USER MANUAL 3
IR 100 USB™

IR 100 USB™ 3
ENGLISCH
SAFETY WARNINGS
xTo prevent short circuits, this product should only be used inside and only
in dry spaces. Do not expose the components to rain or moisture. Do not
use the product close to a bath, swimming pool etc.
xDo not expose the components of your systems to extremely high
temperatures or bright light sources.
xIn case of improper usage or if you have altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in
the case of improper usage of the product or when the product is used for
purposes other than specified. Marmitek does not accept responsibility for
additional damage other than covered by the legal product responsibility.
xThis product is not a toy. Keep out of reach of children.
xDo not open the product: the device may contain live parts. The product
should only be repaired or serviced by a qualified expert.
xOnly connect the adapter to the mains after checking whether the mains
voltage is the same as the values on the identification tags. Never connect
an adapter or power cord when it is damaged. In that case, contact your
supplier.
1. INTRODUCTION
Congratulation on buying the IR 100 USB™. With the IR 100 USB ™ you can
extend the IR (infra-red) signals from your own remote control. The IR 100
USB™ gives you the opportunity to control your A/V equipment when it’s stored
away in a closed cabinet or placed out of sight.
Marmitek products are manufactured with the utmost care and are exceptionally
high quality. Please read this manual carefully and follow the instructions in
order to get the best from this product.
2. SET CONTENT
1x IR 100 USB™
1x User manual

4 © MARMITEK
3. HOW DOES IT WORK?
2
3
1
Place your A/V equipment in a closed cabinet or TV stand. Use one of the USB
ports (1) on your A/V equipment (Digital TV decoder, Blu-ray player, audio
installation) or TV to power the IR 100 USB. The IR receiver (2) must be
installed within your remote’s line of sight and you should stick the IR blaster
LED (3) inside the cabinet. Point the remote at the IR receiver to operate your
equipment through the cabinet doors.
4. INSTALLATION
In order to check that the system works correctly, it is advisable to first test the
set-up you had in mind. To do so, connect everything as described below but do
not stick the components securely.
4.1 USB POWER
No power adapter is included with the IR 100 USB™. You can power the
product by connecting it to a free USB port on your AV device or TV.
Please note the following:
xNot all USB ports are active or provide enough power for proper
functioning.
xSome USB ports are disabled when turning off the set. In that case, you
can only use the IR 100 USB when the unit is on.
xUse a universal USB extension cable if you want to extend the cable.
xIf necessary, use a universal USB power adapter (5VDC, 500mA) if you
cannot use any USB port on your device.

IR 100 USB™ 5
ENGLISCH
4.2 LOCATING THE IR RECEIVER
2
2
Place the very small IR receiver (2) that comes with the IR 100 USB™ so that it
can be seen by your (infrared) remote control and receive the commands (max.
8 metres).
xThe most logical location for the IR receiver is, for example, on the cabinet
in which the A/V equipment is located or near the TV.
xUse the self-adhesive strip which is supplied to locate the IR receiver just
about anywhere you please.
xExperiment with the location before you stick the IR receiver in its final
position.
Note! The sticky strip may lead to discolouration or leave glue residues on
certain surfaces.
4.3 LOCATING THE IR BLASTER LED
3
1
Stick the IR blaster LEDs (3) wherever you like in the cabinet or TV unit. You
will then be able to operate all of the A/V devices in that specific section.
xWith a correct placement one blaster LED can control all A/V devices
placed in the same compartment.
xOr you place the blaster LED on one of the A/V devices in the middle of
the cabinet and the other equipment will be controlled as well by the
reflection of the infraredsignal.

6 © MARMITEK
5. FREQUENTLY ASKED QUESTIONS
The A/V equipment does not respond to signals from my remote control.
Take the following instructions into account:
xThe IR receiver has a receiving sensitivity of about 8 metres with an
acceptance angle of 60 degrees. Range is also dependent on the remote
control used.
xIf the light on the IR Receiver is continuously illuminated, the IR receiver is
probably being disrupted by another infrared signal. Try to locate the IR
receiver so that it encounters as little disruption as possible from, for
example, direct sunlight, Flat Screen TVs, (LCD, Plasma, LED),
fluorescent lighting or energy-efficient light bulbs.
xThe IR receiver does not work with some A/V devices and models that use
higher IR frequencies such as Bang&Olufsen (B&O).
xEnsure that the IR receiver and the IR blaster extender cable are correctly
connected and that these are plugged in properly.
Do you have other questions that have not been resolved by the above
information? Please go to www.marmitek.com
6. TECHNICAL DATA
IR 100 USB™
Power: USB 5VDC 500mA
Frequency range: 30-60 KHz.
IR reception range: ± 8 metres.
IR reception angle: 60° (+30°/-30° from centre).
Dimensions: 90 x 75 x 30mm
IR Extension cable
IR LEDs: 1x IR blaster LED
IR transmission range: 2 metres
Length of cable: 2x 1 metres
Specifications may change without prior notice.
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this
symbol on the product and/or its packaging must not be disposed of with
unsorted municipal waste. The symbol indicates that this product should be
disposed of separately from regular household waste streams. It is your
responsibility to dispose of this and other electric and electronic equipment via
designated collection facilities appointed by the government or local
authorities. Correct disposal and recycling will help prevent potential negative consequences
to the environment and human health. For more detailed information about the disposal of
your old equipment, please contact your local authorities, waste disposal service, or the shop
where you purchased the product.

IR 100 USB™27

28 © MARMITEK
DECLARATION OF CONFORMITY
Hereby, Marmitek BV, declares that this IR 100 USB™ is in compliance with the
essential requirements and other relevant provisions of the following Directives:
Directive 2004/108/ec of the european parliament and of the council of 15 December 2004 on
the approximation of the laws of the Member States relating to electromagnetic compatibility
Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on
the harmonisation of the laws of Member States relating to electrical equipment designed for
use within certain voltage limits
Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on
the restriction of the use of certain hazardous substances in electrical and electronic
equipment
Commission Regulation (EC) No 278/2009 of 6 April 2009 implementing Directive 2005/32/EC
of the European Parliament and of the Council with regard to ecodesign requirements for no-
load condition electric power consumption and average active efficiency of external power
supplies
Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes IR 100 USB™ den
grundlegenden Anforderungen und den anderen relevanten Festlegungen der
Richtliniën:
Richtlinie 2004/108/eg des europäischen parlaments und des rates vom 15. Dezember 2004
zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über die elektromagnetische
Verträglichkeit
Richtlinie 2006/95/EG des Europäischen Parlaments und des Rates vom 12. Dezember 2006
zur Angleichung der Rechtsvorschriften der Mitgliedstaaten betreffend elektrische
Betriebsmittel zur Verwendung innerhalb bestimmter Spannungsgrenzen
Richtlinie 2002/95/EG des Europäischen Parlaments und des Rates vom 27. Januar 2003 zur
Beschränkung der Verwendung bestimmter gefährlicher Stoffe in Elektro- und
Elektronikgeräten
Verordnung (EG) Nr. 278/2009 der Kommission vom 6. April 2009 zur Durchführung der
Richtlinie 2005/32/EG des Europäischen Parlaments und des Rates im Hinblick auf die
Festlegung von Ökodesign-Anforderungen an die Leistungsaufnahme externer Netzteile bei
Nulllast sowie ihre durchschnittliche Effizienz im Betrieb
Par la présente Marmitek BV déclare que l'appareil IR 100 USB™ est conforme aux
exigences essentielles et aux autres dispositions pertinentes de la directives:
Directive 2004/108/ce du parlement européen et du conseil du 15 décembre 2004 relative au
rapprochement des législations des États membres concernant la compatibilité
électromagnétique
Directive 2006/95/CE du Parlement européen et du Conseil du 12 décembre 2006 concernant
le rapprochement des législations des États membres relatives au materiel électrique destiné
à être employé dans certaines limites de tension
Directive 2002/95/CE du Parlement européen et du Conseil du 27 janvier 2003 relative à la
limitation de l'utilisation de certaines substances dangereuses dans les équipements
électriques et électroniques
Règlement (CE) no 278/2009 de la Commission du 6 avril 2009 portant application de la
directive 2005/32/CE du Parlement européen et du Conseil en ce qui concerne les exigences
d’écoconception relatives à la consommation d’électricité hors charge et au rendement moyen
en mode actif des sources d’alimentation externs
Marmitek BV declara que este IR 100 USB™ cumple con las exigencias esenciales y
con las demás reglas relevantes de la directriz:

IR 100 USB™29
Directiva 2004/108/ce del parlamento europeo y del consejo de 15 de diciembre de 2004
relativa a la aproximación de las legislaciones de los Estados miembros en materia de
compatibilidad electromagnética
Directiva 2006/95/CE del Parlamento Europeo y del Consejo de 12 de diciembre de 2006
relativa a la aproximación de las legislaciones de los Estados miembros sobre el material
eléctrico destinado a utilizarse con determinados límites de tension
Directiva 2002/95/CE del Parlamento Europeo y del Consejo de 27 de enero de 2003 sobre
restricciones a la utilización de determinadas sustancias peligrosas en aparatos eléctricos y
electrónicos
Reglamento (CE) no 278/2009 de la Comisión de 6 de abril de 2009 por el que se desarrolla
la Directiva 2005/32/CE del Parlamento Europeo y del Consejo en lo concerniente a los
requisitos de diseño ecológico aplicables a la eficiencia media en activo de las fuentes de
alimentación externas y a su consumo de energía eléctrica durante el funcionamiento en
vacío
Con ciò, Marmitek BV, dichiara che il IR 100 USB™ è conforme ai requisiti essenziali ed
alter disposizioni relative alla Direttiva:
Direttiva 2004/108/ce del parlamento europeo e del consiglio del 15 dicembre 2004
concernente il ravvicinamento delle legislazioni degli Stati membri relative alla compatibilità
elettromagnetica
Direttiva 2006/95/CE del Parlamento europeo e del Consiglio del 12 dicembre 2006
concernente il ravvicinamento delle legislazioni degli Stati membri relative al material elettrico
destinato ad essere adoperato entro taluni limiti di tensione
Direttiva 2002/95/CE del Parlamento europeo e del Consiglio del 27 gennaio 2003 sulla
restrizione dell'uso di determinate sostanze pericolose nelle apparecchiature elettriche ed
elettroniche
Regolamento (CE) n. 278/2009 della Commissione del 6 aprile 2009 recante misure di
esecuzione della direttiva 2005/32/CE del Parlamento europeo e del Consiglio per quanto
riguarda le specifiche di progettazione ecocompatibile relative al consumo di energia elettrica
a vuoto e al rendimento medio in modo attivo per gli alimentatori esterni
Bij deze verklaart Marmitek BV, dat deze IR 100 USB™ voldoet aan de essentiële eisen
en aan de overige relevante bepalingen van Richtlijnen:
Richtlijn 2004/108/eg van het europees parlement en de raad van 15 december 2004
betreffende de onderlinge aanpassing van de wetgevingen van de lidstaten inzake
elektromagnetische compatibiliteit
Richtlijn 2006/95/EG van het Europees Parlement en de Raad van 12 december 2006
betreffende de onderlinge aanpassing van de wettelijke voorschriften der lidstaten inzake
elektrisch materiaal bestemd voor gebruik binnen bepaalde spanningsgrenzen
Richtlijn 2002/95/EG van het Europees Parlement en de Raad van 27 januari 2003
betreffende beperking van het gebruik van bepaalde gevaarlijke stoffen in elektrische en
elektronische apparatuur
Verordening (EG) Nr. 278/2009 van de Commissie van 6 april 2009 houdende
tenuitvoerlegging van Richtlijn 2005/32/EG van het Europees Parlement en de Raad, wat
betreft voorschriften inzake ecologisch ontwerp voor het elektrisch opgenomen vermogen van
externe stroomvoorzieningen in niet-belaste toestand en de gemiddelde actieve efficiëntie van
externe stroomvoorzieningen
MARMITEK BV - P.O. BOX 4257 - 5604 EG EINDHOVEN –
THE NETHERLANDS

30 © MARMITEK

IR 100 USB™31