MasterCraft 054-4605-0 User manual

Fig. 1
General safety rules
WARNING: Read and understand all
instructions.
Work area
Electrical safety
Personal safety
Use and care of power tools
Service
Specific safety rules
WARNING:
WARNING:
WARNING:
Replacing the engraving tip
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE



!
s
Read and understand this instruction manual
thoroughly before using the product. It contains
important information for your safety as well as
operating and maintenance advice.
Keep this instruction manual for future use.
Should this product be passed on to a third
party, this instruction manual must be included.
INSTRUCTION MANUAL
ELECTRIC
ENGRAVER
054-4605-0
!
!
!

2
Fig. 2
Setting the depth control
NOTE:
Operating the engraving tool
WARNING:
NOTE:
WARNING: The engraver will build up heat
during continuous operation. Do not operate the engraver
continuously for more than 5 minutes at a time. After 5
minutes of continuous operation, the tool must be turned
OFF and allowed to cool down for at least 5 minutes.
!
Fig. 2
Fig. 3
!
Fig. 4
three years from the date of original retail purchase
These warranties are subject to the following conditions and limitations:
i.
Additional Limitations
.
Notice to Consumer
TOLL-FREE HELPLINE: 1-800-689-9928