4. Installation
1. Check the contents of the delivery: Inverter Control Panel, 7,5 m (82 ft) RJ-11 cable, this manual.
2. Use the following screw hole and cutout dimensions for mounting of the panel.
3. Optional:
a) In case of Ignition Lock: remove the circular back cover, by removing the two screws, and
position the jumper over both pins. Replace the back cover.
b) In case of Remote Override or Ignition Lock: run a wire from the boat/vehicle's ignition switch
to the AUX. input. Note: this wire must be protected by a fuse. See chapter 3.
4. Route the RJ-11 cable, provided with the panel, from the RJ11 port on the back of the AC Master
Inverter Control Panel through the cutout.
5. Position the remote into the cutout and secure it with two screws.
6. First switch the AC Master unit OFF, then connect the RJ11 cable to AC Master unit. After that
put its main switch in the “REMOTE” position, see user and installation manual of your AC
Master unit.
7. Press the ON/OFF switch on the remote control panel to switch the AC Master unit ON.
8. Verify the status LED is on, both on the remote control panel and the AC Master unit.
5. Correct disposal of this product
This product is designed and manufactured with high quality materials and
components, which can be recycled and reused. Please be informed about the local
separate collection system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old products with
your normal household waste. The correct disposal of your old product will help prevent potential
negative consequences to the environment and human health
